View Single Post
  #1 (permalink)  
Old 07-20-2003, 08:00 PM
gonzo891 gonzo891 is offline
Junior Member
 
    
Join Date: Feb 2003
Location: buffalo new york
Posts: 3
Send a message via AIM to gonzo891
1055787

Well i did it. it tok some time but i flipped my jeep! damn snow covered roads! well it put my jeep in the garage long enough to get caught up on a few problems i have. oil leak waz fix a few things here a few things there but i decided to redue my rear brakes the driver side went great no problems but then the passenger side came and as i took the drum off grease was everywhere i know it's not brake fluid because i just replaced the wheel cylinder so i figured it waz either an inner or outter seal. so after some hammering i got the nut off the far end of the axle but i can't seem to get the axle out i need to replace the seals somewhere in the axle but i'm at a stand still right now any help would make this project just that much eaiser. i have a CJ-7 with no lift and 31 tiresthanks for any help you can give[addsig]
Reply With Quote
View Public Profile Send a private message to %1$s Show gonzo891 gallery
Sponsored Links - Removed for registered members