|
Re: diff fluid? with arbs
on the Dana 35's, lift the rear end up( tires off the ground) and re-tighten the pinion nut till you get 15 ft lbs of turning resistance on the pinion nut, to get the right preload on the pinion bearings, some where around 200 ftlbs of torque.
That is where you set the crush sleeve at initial set-up.
__________________
The tricky part is not being able to drive it in....but being able to drive it out.
2001 TJ 4" of lift, long arm kit,ARB's F/R with a viair 450c. Custom front bumper,rocker panels, and sliders.
Only 220 miles to Moab Only 1622 miles to Red's fridge full of (non-utahian) beer
|