|
1045058
i've been having trouble with my idle speed actuator/motor (ISA) on my 90 yj 2.5L TBI. it wasn't extending and retracting properly to control the idle. i took it apart and it was all gummed up with dirt and oil, so i cleaned it all up and installed it.
now the idle will not drop upon startup. it goes up to about 2500 rpms and doesn't drop (i let it run only for a minute or 2). when i installed the ISA it says to make sure it is fully extended upon installation so i did that.
if i let it idle for a little longer at 2500 do you think it will eventually drop? the battery was disconnected so maybe the computer needs to reset. i am just worried to run it at high onstant rpms too long because i have a new engine in that i am breaking in (no high speed or rpms for 500 miles).
anyone have any experience with these?[addsig]
|