|
12-03-2004, 06:38 AM
|
||||
|
||||
|
Blowing switches, fuses
a few weeks ago i noticed that the wipers were kinda "jerky" if i used them when there wasnt alot of water on the windshield. this morning when i turned the wipers on and then turned them off, the wipers just stopped in the middle of the windshield. they didnt cycle back to the beginning. i tried them a few more times with the same results. whats the deal and how hard is it to fix whatever needs to be fixed.
__________________
remember: professionals built the titantic, amateurs built the arc 
|
||||
|
| Sponsored Links - Removed for registered members | ||
|
|
12-03-2004, 08:39 AM
|
||||
|
||||
|
?? interesting. Mine do that too sometimes, but I think it might have to do with the intermidiat wipers, instead of there being a on and off, there is a resistor that sets the cycle, perhaps it is wearing out.
i dunno
__________________
It's a jeep Thing, you wouldn't understand! Well I caught your Jeep thing and now it burns to Pee! -Johnny- 
|
||||
|
|
12-03-2004, 11:29 PM
|
||||
|
||||
|
check your wires going into the wiper motor - i had that prob w/the rear on my old 91's hardtop - it wouldnt return to its "prone" position and when i checked it there was a wire that came loose that powered it back when the switch was turned off... just a shot - hope it helps!
__________________
Bob in Vegas 89 YJ-4.2/5spd,Herculiner tub,4"HellCreek Lift,Cable front axle,Flush LED,Hella,KC,33x12.5 BFG M/T on Eagle Alloys,flatfender,55w backup lights, Steves Jeep Rear bumper,Bestop extendatrunk w/top mounted spare,Cobra CB w/rear dual antenna, misc. trail rash 
|
||||
|
| Sponsored Links - Removed for registered members | ||
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 01:42 PM.