Slave cylinder

[Ragtopman]

I have to change the slave cylinder in my 91 YJ 4.0l AX15 internal salve. The Chiltons manual does not give much information on this. 1st how do you get the old pin out? Then how do you get the new pin and washer on it,is it just tapped in? Also the plastic clips that hold the slave compressed, do i leave them on until assembled? do they pop off themselves when the clutch pedel is depressed?

[Bounty__Hunter]

Definately leave the straps on, they will pop off when the clutch is first used after assembly.

The roll pin generally stays in the tranny, just remove the clip to slide the slave cylinder on and off.