2006 Jeep Seat Repair

[marvinb]

I'm new to doing any type of repair to my jeep, but the passenger side front seat will not lean forward and roll to allow access to the back seat. I know the cable is broke, but does anyone have any diagrams or suggestions on 1) How to remove the seat and 2)How to repair/replace the cable that makes the whole thing work? Thanks! I love my jeep, but it makes getting my lab in the back very difficult!!

[SteelHeadz]

1.Remove the seat. 2.Disconnect the j-straps at the bottom of the seat back.3.Remove the bottom hog rings.4.Remove the upper hog rings.5.Remove the support rods from the seat back.
6.Using a trim stick C-4755 or equivalent, remove and discard the seat release handle knob. Fig. 1 7.Remove the screw and remove the release handle bezel.8.Remove the seat cover and cushion.
Fig. 1 - FORWARD FOLDING SEAT RELEASE HANDLE

1 - SEAT BACK 2 - BEZEL SCREW 3 - RELEASE HANDLE BEZEL 4 - RELEASE HANDLE KNOB

2.Disconnect the release cable folding end. Fig. 1 3.Remove the inboard recliner.
4.Disconnect the release cable assembly at the inboard recliner, from the support bracket. Fig. 2
5.Disconnect the cable assembly at the slider and remove. Fig. 3
Fig. 1 - RELEASE CABLE/FOLDING END

1 - CABLE END CLIP 2 - CABLE HOUSING 3 - CABLE ASSEMBLY



Fig. 2 - RELEASE CABLE/RECLINER END

1 - CABLE ASSEMBLY 2 - CABLE HOUSING 3 - SEAT CUSHION FRAME 4 - CABLE SUPPORT BRACKET
Fig. 3 - RELEASE CABLE/SLIDER END

1 - CABLE HOUSING 2 - CABLE END 3 - SLIDER 4 - SEAT CUSHION FRAME