no power to coil

[jgalloway]

just put a new engine in a 1997 jeep wrangler 2.5 and i have no power going to the coil i put a crank position sensor and i have moved the relays around incase it is the asd relay, i have power to the fuel this is the third time i have put the engine in in the last 2 months and this is the only problem i have run into please help if anybody can.

[Mikey4x4]

Need to test the ignition switch and trouble shoot from there

[Jester32]

Ign fuses all ok? Ign relay good? Check for power at fuse panel and trace wire back to pcm and check power.

[Mikey4x4]

You may such ECM on here I remember reading something about not getting fire to coil and the fix was changing screws

[SteelHeadz]

I'm not sure if the 97 model has a CKP sensor but if it does, make sure the sensor is properly plugged in.

[jgalloway]

thinks for the information but i got it running, i cleaned all my grounds and rechecked the timing and it fired right up

[gennybro]

F'n A, been folowing this thread,glad ya got it going.