440 cj-7

Gantec

New member
Almost done ...440,,727,,dana300,,dana60,,14 bolt detroit locker,,37" baja ta on hummer H1 wheels .pictures of the impossible soon too follow.
 
Owensound ???? Used too deliver stainless tok hobart all the time nice place .... Will send pics this weekend!
 

I have some older photos of this project showing the 440 just after install.

A few fresher pics show a bit of progress. Things like fenders and half the wheels have made it into place.

It's currently pushed out of the way thanks to the kid's IROC. He's only home for another week or so, so the push is really on that right now. Then the Jeep can take it's rightful place again.
 

Attachments

  • Jeep1.jpg
    Jeep1.jpg
    99.7 KB · Views: 605
  • Jeep2.jpg
    Jeep2.jpg
    84.9 KB · Views: 570
  • Jeep3.jpg
    Jeep3.jpg
    743.8 KB · Views: 351
  • Jeep4.jpg
    Jeep4.jpg
    643.2 KB · Views: 369
As with everything i usually don'really know. So far 1978 dodge ramcharger 440 headers seem too look like the best choice ( centered collector ) and since i have some 3 inch pipe and flowmasters from my last truck well ....free is for me .. Total so far is around 1800.00 dollars!!
 

Headers on .had to cut no1 pipe and put it around the steering shaft .234.00 for headers saved 300.00 on steering parts by using stock shaft . Rear drive shaft on .tattons 1310 cv at top 1350 at bottom for 14 bolt 330.00. Front calipers,pads,lines. Starter and ignition wiring. total 2488.00 so far
 
Back
Top