Recent content by Bowhunter3d

I have a question that I have been digging thru the wiring diagram to try to figure out is the ckp signal wire pin 35 from the pcm shared with any other sensors? So after I had ran new wires to the ckp I went back in and put power and dround back to the original wires as well because I figured...

Update 2010 Jeep Commander... Begging for help... So update... I ran new wires from the wire harness 5 inches from where it comes out of pcm and down to the ckp sensor I'm still getting P0335 along with a new list of codes... :deadhorse::deadhorse::deadhorse: so now I'm not sure what next step...

Edited 1st post entered wrong code correct code is p0335...

Yes rest codesUsed oem ckp No paper gasket Checked coils and swapped no issues there battery is good and clean The problem is with the ckp somewhere....

I have a 2010 jeep commander giving code P0335!!! NOT P0355 I entered wrong code when typing last night!!! I have replaced the ckp sensor with 2 different sensors and get same issue. On the dash it has the red lightning bolt flashing and the esp and bsm lights on. When cranking it takes a good...