Recent content by Bullet3600

Now it is the u joints in the front drive shaft. Have it out and doing that now Arghhh! :x

I just had the front U joint's and wheel bearings replaced. I still hear a clacking sound coming from the front similar noise to the old bad u joints just not as loud. Brakes are ok so what could this be?

I will check that out tonight, That grommet in the door is a mess to get too and one of the worst designs ever. I will let you know, Thanks

Hi all it's been awhile, On my 96 Grand Cherokee yesterday the relay for the power door locks started to tick like crazy, the door power door locks no longer work and it only ticks while the doors are closed. I replaced the relay with a new one and same thing also the fuse is good too. Any...

Probably the same issue I had with mine last week, the thermostat was stuck open, actually it was broken and staying open. replace your thermostat and it should be fine, just remember to install it facing the right way.

Are all of your vacuum lines reinstalled correctly? the engine will lope and run rough or maybe a clogged pcv valve? have you had a compression test done since the head gasket was replaced?

Ray at Jeep's Unlimited is excellent. I think their name on eBay is zeusjuice or something like that.

Well after so much frustration I gave in. I had Jeep's Unlimited in Providence fix it. It was the ECC Computer on the front of the drivers side fender. So after all the BS and $300.00 later it is running again, at least until the next problem. Bill

I swear once these 2 jeeps are fixed they will be sold and I will never own another jeep product ever!!!! The 95 Chrokee Sport 4.0 auto trans is the own that drove me nuts last week. It seemed ok until the cold settled in now it won't start for anything. You turn on the key and all the relay...

Ya gotta love Jeeps, if the is oil somewhere a Jeep has probably been there...lol

I used the blue rtv sealant with the gasket and let it dry for a short, it worked well to hold it in place. Be extremly careful not to snug up the bolts to tight, they snap very easy with to much pressure.

Well it's fixed, it wasn't the CPS after all. I had a broken wire on the bottom of the distributer and get this, the major problem was a broken vapor vent on the top of the gas tank. No idea how it got broke and fell into the tank but it is replaced now and running like a charm. Thanks for...

How do I remove the CPS? There isn't any room to get a wrench or socket in there.

This is driving me over the edge. 95 Cherokee 4.0 New battery, wires, plugs, rotor, cap, coil and fuel filter etc. The damn thing will only start when it wants to, It seems to start the worst in the cold but it has fuel. Spark is random, sounds stupid I know but it sometimes has spark and...

Well the fuse checked out ok, does anyone know where the vacuum modulator is located on the trans?