Recent content by Jeeper99

Anyone have any more suggestions? :coffee:

Yea, i t does it on cold starts too. Pretty much anytime I first get in and initially drive off. It does it the same if the engine is warm or cold..

I went out and looked today and didn't see any kind of heat shield on the injector? I've never noticed one on it the whole time I've owned the Jeep. After cleaning the Manifold Temp sensor, I thought it helped, but thought wrong. It's still acting the same way when I start it up and begin to...

The O2 Sensors I got were factory replacments. What do you mean by faulty or missing heat shield on injector#3? Oh and it idles very smooth, always has. The engine backfiring through the manifold is once in a blue moon and it is very very faint. It hasn't done it in about a month..... I took...

Thanks for all the replies and pointers. I have taken the TB off and cleaned it, as well as TPS and all that. It has a newer distributor/rotor, plugs and wires. I also replaced both O2 Sensors a year or so ago. There is no raw fuel smell, no leaks that I can see. No codes or check engine lights...

Anyone have a clue as to why my wrangler has a studder/hesitation when I first get in it and start to drive? I've heard a faint backfire through the throttle body. Once it clears out, it is fine the rest of the time I drive it. But if I park it for 10 minutes or longer, same thing happens...

Thanks Jim!

I havn't checked the amp draw because I don't have a meter. With my busy work schedule, I havn't had time to borrow one from my uncle yet. As soon as I get a reading, I will post it up. Thanks again for all the help guys! It's much appreciated!

*****UPDATE***** Well, After finally braving the cold weather, I started trying to pinpoint my Blower motor issues. I directly wired the motor to the battery and it worked fine. Then went through and checked the wiring. All was fine. Then pulled the dash and the HVAC switch controls out...

Thanks guys, I'm going to see if I can pinpoint the issue and I'll let you know what I find! Thanks alot for all the info! It's greatly appreciated! Jon

Thanks for the advice! If the resistor is bad, would it fail to work on all 4 settings, then the next day, be working again? For some reason, that' what happened. THe next several days after my initial post, all but the third setting was working again. But today, none are working...

I had a new issue occur with my fan control switch today. Several months back, the 3rd (or medium High) setting on my blower switch quit working. Low, Medium and High worked fine. Now today, The blower was working fine and just quit. None of the settings are working, which leaves me with no...

Thanks for the links and helpful Info! i have read alot of the write-ups, but am still not sure on what kind of cable and mount set-up to get? Are the COAX cables all interchangeable with all radios and Antennas? Just a shot in the dark, but if you guys get a chance, send me a link to...

Thanks for all the input! Of course, when I found the radio, there was no manual. There is 3 wires coming out, black orange and red. Black = ground, Orange says battery+ and where would the red go? A switched 12v?

I was helping my mom move out of her house earlier today and came across an old Cobra 19 Plus that belonged to my late uncle who was a truck driver. I was thinking of putting this in my Jeep for the trails etc.... since it is a small radio. Is this an OK CB to be so old? It looks brand...