Once again we'll be holding our annual Open House rides. May 18th at 10am at the Gilbert Minnesota ORV park. More info here:
openhouseinformation
Come on out and enjoy a great day at the park, get a some grub, and maybe even win some prizes.
Will do. If I go for a small production run I'll post it back up in this thread. As far as other forums, just a couple local midwestern forums. I've thought about going to some other forums, but I do this stuff on the side and don't want it to consume to much time. If there is enough interest on...
So far your the only one to express any interest. But that makes 1 and I still need another 9. I can let the sign up run a while longer, however my quote from the cutter is only good for 30 days. I'll leave it open for another 2 weeks then we'll see where we are.
Thanks for the interest.
Basically what the title says. I've had a couple people interested in some front bumpers and I can get a better price from my laser guys if I cut a full sheet instead of cutting a partial sheet. Bumpers are $155, but if I can get 10 people with some interest and commitment , the price would be...
I've had Silverstars in the TJ for 6 yrs with no problems and had them in the YJ for 4 yrs when that sold. Only time I've had to replace them on the TJ was when a ninja log jumped out from no-where on the trail and stuck me right in the headlight....Damn Ninja logs, don't trust em.
The rocker are bare metal and currently not counter sunk. I can always countersink them if you want. The hardware I sell with the rockers are stainless steel flat socket cap screws, these of course need to be counter sunk. You could also use button socket cap screws. They attach on the inside of...
Your jam nuts that is....I had my rear axle side Johnny joint pull out from the lower control arm at about 55mph last week. Not fun driving into traffic at a 45 degree angle.
Just a friendly reminder to check and tighten your jam nuts often:lol: