Recent content by Jeepsburg

Haha, your deff right, i did not think of stuff falling into them, I'll plug 'em good Thanks a bunch, i guess that answers all my questions. Happy Jeepin' JT

1. Is it bad at all to not have the heater hooked up? If I do hook the heater up to the switched 12v power source, will it always stay on even after it has warmed up? (would that be bad, such as it staying hotter than it really needs to be?) Or should it automatically turn off? 2. There were...

It's FIXED!! I know it has taken a long time to get here, but I finally finished my Fuel Injection conversion swap. I still have a few questions thought if someone knows the answer; 1. The instruction mentioned something about the manifold heater needing to be connected (the swap un-connects...

It's FIXED!! I know it has taken a long time to get here, but I finally finished my Fuel Injection conversion swap. I still have a few questions thought if someone knows the answer; 1. The instruction mentioned something about the manifold heater needing to be connected (the swap un-connects...

Just wondering, Do you also have the Howell Fuel Injection kit?

Ok, so I guess I will go with a 195 thermostat. My mech told me I should replace it because it is changing about 20* Thanks for your replys

Is it bad if it keeps changing temp? What is a good temp for Fuel injection system?

Ok, I have a carburated 89 YJ, and I am in the process right now of switching it over to fuel injection with a Howell kit. I had to replace the exhaust and intake gasket on the head to pass inspection and well I had the engine coolent drained, I was told it might be wise to replace the...

I have an 89 YJ. I think I am having a bunch of problems with my old carb (bad idle, will stall sometimes after starting or when not warm yet). So I really wanted to do a Fuel Injection swap. I had a few questions though. 1. What is a good model to use 2. Where can I get it 3. How much does it...

taking it to the shop I'm going to be taking my Jeep to the shop on Wednesday, so I will let you know how it all goes. Jon.

I have heard I should check for vaccum leaks, (but I don't think its that cause right now it only sputters when it hits a bump), so no, I have not checked for vacuum leaks, but I think I'm going to take my Jeep to a friend mech. around my place on Tuesday (18354, PA). The mech at my school...

I am having the same exact problem with my 89 yj with a 4.2L inline 6. I put it in the shop at my vo-tech for a month, and... I went to drive it home and as soon as it heated up to normal operating temp, it started running around 600 or 500 (hundred) rpms. it was really low and you basically...

Hello, I have a 89 inline 6 manual carb YJ. What kind of problems have you guys ever had with your stock carbs? I believe my carb is going / not rebuilt the right way. Is it easy to rebuild a carb? What does it mean to have a "nutter" or something like that done on the carb? Is it a lot better...

thanks Thanks, I'll check those out. Any other ideas? Jon.

Hello, I got a 1989 YJ, inline 6 4.2 manual engine and... My jeep used to run real rough when it got hot, i then replaced the distributor and it still did not have real good power so i cleaned out the carb and replaced the Ignition Control Modual, but it still losses some power when ever you...