Recent content by Northman111

:lol: Ah, thank you so much!!! That had me stumped.

:???: Hi peoples!!! I have question about shifting, I have a J-2000 4x4 1973. It has a threespeed manual trans with manual locking hubs. The transfer case shifter is of the single stick version. I have found after taking it apart & cleaning it out & filling it back up with fresh grease it...

:???: Is it possible to convert the front drums over to disc & if so, how much work involved in doing so.

Wow!!! Good job, make sure you slam door a couple of times. That should take care of that pinch point & your rubber seal. Good luck.

Ok peoples, I got a little bit newer distributor & coil & ignition module & partial wireing from a AMC hornet with the 258 engine!!! Now I have a few questions. #1 Can I buy the distributer cap adapter & cap like what Terry Mason has & mount that on this distributor? & #2 I also have a...

Terry. I just got a distributor & coil & wires out of a 1992 Jeep Cherokee, with a 4.0 Looks like it will drop right in my older point ran 258. Only thing I couldn't find the ignition module for it?? Any Ideas??

It was up for sale on Craigslist.com I traded a German Mouser model 98 for it!!! It was a good deal. If your truck still has the stock springs, I would appreciate it. Because my truck is in storage about 244 miles North of me. Now I found a junk cj at the scrap yard and it has the 258 engine...

I just got me a barn find. 73 J-2000 4x4. And boy do I need help on this critter.

Which engine do you have?? Six or eight. Either way sounds like you sucked up some gunk in the carb. ( Fuel side )

I will check with one of my buddys that has some of the old postal jeeps. I do remember him going on about a four cylinder with wackey fireing order. you probaly have it right but sounds like the vaccum advanc is messed up.

Ok peoples. I just got myself a barn find!! 73 J-2000. It has the 258 six engine & three speed trans. I need to know if stock leaf springs from a standard jeep will swap out? ( CJ maybe ) or will I need to go custom made. Also wondering if the distributer can be converted over from point and...