Recent content by rockfishray

Went to Rausch Creek and had a blast

Does anyone know what the max warpage allowed is for the manifold side of the head is on a 1989 4.2 ? i measured .002 of warpage i had my intake milled thinking that was the problem but still have a leak that make me run with the choke on all the time . i pulled it all back apart and mesured...

These brackets mount in 5 minutes into existing door hinge with one bolt (included) and uses your mirrors and locks into specific mounting angle $50.00 a pair. P.M me if intrested.

their is a channel up under dash should be under your evaporater it gets clogged with dust-dirt-and the occational dead mouse

took my doors off

it is your drain hose for your evaporator it is nessasary to drain water away from it if your passenger floor is getting wet the trac the water runs down is clogged and water isnt getting to hose to drain outside

hey policemonkey you got it we had to pb blast transfercase shifter and grease it works great now thanks for your reply

We installed a aussi locker in the front on the test drive we snaped a O.E 1988 u-joint replaced it but now it wont release drivers wheel out of 4 wheel drive and ideas thanks

Installed Aussie front locker and G2 diff cover with drain plug

Thanks i will call Rough Country has been awsome to deal with will update thanks again

ok my 89 yj with a rough contry 2.5 suspenison lift sits 34" at the front wheel well and 36" in the rear i have a winch in the front and after a couple of months i notice the difference my question is about front shacle lifts and how it changes the geometry of everything. Does anyone have REAL...

i agree looks bad ass

All vehicle manufactures do the same thing try getting toyota to warranty leaking struts they say its normal get the local newspaper involved they can do wounders

Did a couple things latley new HEI distributor Motor craft 2150 Carb and smity built src front bumper with a 12k winch and 4 lights

you should replace both at the same time and get new pigtails as they will be full of oil i work at a goodyear dealer and we see it all the time just fixed a p1391 last week and the pigtails we so oil soaked you could pull the wires out of it by hand Good Luck