Recent content by stumblnyj

After a super long break, I m back and ready to sideline my Jeep again for several months or even years. I just picked up some 1 ton axles for my next project of swaping them into my YJ. Before I start has anybody tackled this project and have tips or tricks they learned from their project? Also...

I just recently did my rear frame ends. I got the stuff from Taboo Customs. He also posted a well informed video of the process involved. I was a little intimidated before I started but I was surprised that I got everything done for both sides in about six hours. I dropped my tank and used a...

Found this photo from 2004 when I drove my Jeep through the Patuxent River in Bowie, MD

<p>Found this photo from 2004 when I drove my Jeep through the Patuxent River in Bowie, MD</p>

Thanks for holding my money, enjoy the interest you earned. Now I will take my $20. Thanks

It is fuel injected. He was told the donor vehicle was a 98 1500 Terry I will take some pics tomorrow.

Has anybody put a Chevy 350 in a TJ? How did you go about making it run. Trying to help my brother figure out the rat nest of wire the guys he bought his TJ 350 from. The jeep ran fine for about a year before it started to run like it was not mixing air and fuel correctly. We have gotten codes...

I was looking into doing this same swap. I ended up doing a Chevy 350 swap. The motor mounts will need to move forward on the frame. The AX5 would work but depending on how you drive it may hold or may not hold up. I had a hard time finding odds and ends parts that you don't think of or realize...

I did a sbc swap in my YJ last year and used a Cintech wiring harness and put Autometer gauges in. I did it that way to ease the instillation. Hope this helps

TerryMason, according to DOT laws you do not need a windshield but do need working windshield wipers

I'm looking to get an opinion or some advice regarding the 4x4 cable lock install on a YJ. I already installed the cable about 6 years ago. But recently did the sbc swap and failed to realize the cable was too close to the exhaust. Long story short the cable melted and will no engage anymore. So...

Finally got my sbc swap done!!!

My shifter boot for my YJ is as stiff as a board. Is there anything I could soak it in to soften it up? If not besides buying a replacement is there a nice universal boot(s) that would work with it. I have seen some leather options but to me they look silly in a rugged Jeep. Thanks

I have recently completed a sbc swap in my YJ. Now I'm doing all the fine tuning and have stumbled onto the speedometer gear. I started with the 4 cyl and 33" tires and a 4.11 rear. The gear that came out of the transfer case was a 35 tooth and the speed was almost correct. When I did the swap I...