Search results

1041051 THERE IS A SERVICE TECH BULLETIN ABOUT THIS PROBLEM IT INVOLVES REPLACING YOUR ROTORS AND A SET OF REVISED CALLIPERS [addsig]

1041052 SOUNDS LIKE A CLASSIC CASE FOR A FUEL PUMP PROBLEM HOOK A FUEL PRESSURE GAGE ON YOUR FUEL RAIL IF IT IS AROUND O PSI REPLACE YOUR PUMP. IAC MOTORS USUALLY CAUSE A CAR TO DIE AT STOPS ONLY OR IF YOUR BATTERY IS LOW THE IAC MOTOR WILL LOOSE ITS MEMORY AND DIE AT STOPS[addsig]

1041053 LOT OF THE PROBLEMS YOU ARE HAVING ALL SEEM TO HAVE A COMMEN SOURCE I WORK ON JEEPS AND I ALSO HAD A PROBLEM KIND OF LIKE THIS IT WAS THE POWER CONTROL MODULE GOOD LUCK[addsig]

1041054 THE VALVE YOU NEED TO REPLACE IS GREY AND AT THE REAR OF YOUR VALVE COVER ALSO YOU WILL NEED TO CLEAN THE OTHER END OF THE VACUMN TUBE ON THE INTAKE THAT IS WHERE THE PROBLEM LIES IF YOU LOOK IN THE HOLE AND IT IS CLOGGED JUST CLEAN IT OUT[addsig]

1041055 IF YOUR VEHICLE TAKES A LONG TIME TO START WHEN YOU FIRST START IT IT IS MORE LIKLY THAT FUEL PRESSURE IS BLEEDING DOWN (A VERY COMMON PROBLEM) THERE IS A TUBE ON YOUR FUEL PUMP THAT HAS A CLAMP THAT LOOSENS UP YOU NEED TO REMOVE YOUR FUEL PUMP AND TIGHTEN THESE CLAMPS ALSO CAN TRY TO...

1041056 WHEN THE COMPRESSOR DOES THAT THAT IS A SURE SIGN THAT THE FREON IS LOW MORE THAN LIKELY IT IS ONE OF TWO THINGS THE EVAPORATOR OR THE HIGH PRESSURE HOSE(THE HOSE FROM THE COMPRESSOR TO THE CONDENSOR) GOOD LUCK[addsig]

1041057 The noise you hear behind your glove box is probably the evaporative system soliniod it is normal it is part of the emission system. the other noise is probably the blend doors finnally engaging. see if this happens more on the high ac blower speed than any other speed if it does it is...

1041058 On the v8 grand cherokees there is a two part fan shroud if the bottom piece is missing it will overheat i have seen it a hundred times i have heard the same story so make sure it is there if it is then go the radiator route good luck[addsig]

1041246 I have had the same problem with a 97 jeep cherokee. What I found was the speedometer gear was chewed up and had to replace the gear. There is also a procedure to do that you count the teeth on the gear and on the housing there are the matching number the number has to be at the 6...