Search results

Sorry not the MTX Jackhammer JH202 it's the JH404

Terry I seen your write up, I am definatley not that handy haha otherwise I would totally go for it, I'm really new to the car audio world, but I know what sounds good and the set up I have planned out I have a feeling is going to sound amazing, the enclosure I was looking at is ported already...

Ok so just got my wrangler all together freshly painted lift installed bigger tires the whole 9 yards pretty much I want to upgrade my sound system now so it sounds a little better I have the subwoofer picked out it's already in an enclosure I've got my amp picked out it's a mtx jackhammer 4...

252000 still going strong.

Doing a 5.2 magnum swap with transmission out of 1997 dodge ram van what else should I pull from the donor vehicle other than the engine transmission wiring harness and ECM ?

My springs perform great, I love my lift I don't see why people call it malljacker when alot of guys use it for their rigs and have awesome.

All stock rear end...with 10" of lift wow. That whole rear end probably had enough tell him to change out the whole rear and put in a dana 44 or ford 8.8 or if he wants to go big off the top a Dana 60. Anything is stronger then stock I think the rear on that is an Amc 20.

Personally I think skyjacker is the best, but most of it is matter of opinion.

I believe I have a 23 spline input shaft because I have a 4.0 auto 3 speed it's the TF999 I was looking around to see if the 5.2 magnum would bolt up to that transmission but could find much so I figure if I have the transmission that comes with the 5.2 which it could be 44RE 46RH 46RE I was...

I'm looking into a 5.2 engine swap and need to know Will a 46RH or 46RE transmission bolt up to a NP231 transfer case?

You could cam it, check out comp cams. You could throw a set of headers on it you could supercharge or turbocharge you can port the heads you can upgrade your ignition system you could get a Jet performance chip although alot of people say they don't work, but some think so I personally think...

31x10.50R15 Dick Cepek Crushers!

Ok, so the transmission from that truck wouldn't work with my jeep? I know that the truck wouldnt have a transfer case, so I could buy the adapter for that but for the transmission, is it going to make a difference with it being 2wd and the jeep 4?

Truck is a 2 wheel drive can this still work?

Weird :S never heard of that before and it's no problem man.

Yeah it was my thread sorry if it confused you to much, I have one answer for your driveshaft and transmission problem. You'll have to get shorter drive shafts I think and I'm pretty sure Tom woods makes really good ones.

Should it be on the same side as the jeeps transfer case? And when you say clock it does that just mean angle it? And should I use the axles from this truck at all? Cause I'm sure it's got a big axle out back being a 2500 and all, will I have to change the fuel pump?

Ok, if anyone can answer those questions above that would be great! Also found a donor today for about 850 it's a silverado from 1993 it's a 2500 series I have the engine already that I'm rebuilding to make it a good durable engine but there's another engine I plan to take re starter and...

I love fishing! Try to go as much as I can but living in the middle I don't get to go as much as I want to usually about 4 months of the year (spread out across weeks of course) but fishing is the best past time. I don't make lures though I do however play fishing games haha perhaps you should...

Injectors or maybe camshaft problem. But I'm not 100% sure.