Search results

Today, at the off-road park, I lost 4 lo. My transfer case would shift into 2 hi, 4 hi & neutral but no 4 lo, just a spongey feeling in my shifter where 4 lo should be... well, I went to the articulation area to get a good look under the Jeep at the linkage and this is what I found. I'd...

Arriving at the camp ground Ribeye on an open fire Quite the camp with some colorful characters Obligatory "flex" pic Stuffed wheel well

Banged up my skid plate playing with the cool kids... should I replace it?

I went to dive my 2018 JKUR Recon manual transmission to work tonight & got a CEL & a code reading p050b "Cold Start Ignition Timing Performance". It didn't run any different than normal. I tried clearing the code but it didn't disappear. I ended up disconnecting the battery for 10 mins & that...

2018 WK2 Altitude for Momma Bear. I tried to talk her into a Trailhawk but she wasn't having it.

I got the ok to get a winch for the Jeep. I grabbed the Badlands Apex 12,000. Now I'm just waiting on better weather to make my kids (10m & 18f) install it ��

Recently, my fiance's coworker was wanting to scrap her 1999 Grand Cherokee Limited (157k mi) because she was afraid it was going to blow up & the motor was bad (no oil pressure). My lady suggested to her that I look at it & that it might not be as bad as it looks. After code reading turned...

POR15 3 quart kit, ✔ Scouring pads, ✔ Wire wheels, ✔ Cutoff wheels, ✔ Blending discs, ✔ Heavy plastic drop cloth, ✔ Degreaser, ✔ Herculiner, ✔ Dave's Customs Unlimited full boat sides, ✔ Clean interior of Jeep, trying my damnedest Xyelen (Xylol), needed 16g sheet metal patches, needed I got...

Jeeple, I'm in need of tech help!!!! My '05 TJ is dead in the water. It won't start. I just replaced the starter but that wasn't it. I tried to jump the starter, it turns over but won't start. What do I do. It's my only vehicle. I have power to the fuel pump & it primes for pressure but when I...

The BFGoodrich KM2s that I bought have lasted 4 years (2 are still good) but with the Jeep doing less trail & more grocery getting, I've decided to start the switch to all terrains. I like the BFGoodrich T/As ($165 for 33x10.50x15/$190 for 33x12.50x15)) but I'm on a budget... anybody have any...

Ok, my buddy's TJ is acting up in that it's popping the running lights/dash light fuse... like as soon as he replaces the fuse with the key in the off position. He said the front driver turn signal socket looks like it got heated enough to melt the Chrysler emblem off of the socket. I'm at a...

My u-joints are shot & I need to replace them... but I'm not sure what it's gonna take. I've got basic hand tools/no air tools :-( just trying to get an idea if I can do this in a few hours or will it take longer.

Ok, so I just installed some LED stop/turn/tail lights & my lovely lady was asking about reverse lights. Are LEDs bright enough to do the job? How would I go about hooking them up to the factory harness? I only want the stock function, I don't care about turning them on when not in reverse. All...

looking to install these but electrical isn't my strong suit. Do I just need to replace the flasher or do I need to install a resistor in line?

I had some speedometer issues in the way of it stopped working on account of some pinched sending unit wires being the 4WD shift linkage. I did a SYE & freed up the wires & speedometer works again... my cruise control never came back. The green light comes on but there is no activation when I...

My 2005 TJ soft top has seen (more than) it's share of abuse & neglect over the years. My zippers barely fit together correctly when I bought the Jeep, the passenger side from seat leaks from who knows where, the stitching is starting to leak, the passenger side soft window developed a crack/rip...

I recently had a rear u joint failure where my drive shaft slid off the yoke and got all banged up on the road. Afterwards it had some nasty drive line vibration (starting around 30 mph) so I installed the SYE kit that I bought thinking that would remedy the situation... well I'd kinda did. It...

I'm looking for a D60 for the front end of my TJ but where do I start? I know it's gotta be a Ford if I'm picking from junk yards but what years are best? How much work is there to make the steering jive? I'll be doing a long arm to the front & have a friend who is a professional welder who...

Ok, my tj developed a vibration when I accelerate or maintain speed. It goes away when I let off the gas but returns when I touch the gas. Nothing but front brakes are new & I found the passenger caliper bolts & knuckle to be stripped. It's not Death Wobble but more like I'm driving on the...