Search results

I have been removing the dashboard on my 2011 JK to replace the heater core. I have searched the YouTube videos and any write-ups and I have come up empty handed on how to get the passenger airbag out. I have separated every clip and the bag still seems to be held by something directly in the...

Recently I sold my 89 cherokee and purchased a 2003 grand cherokee. I love it. But the directional signals work sometimes and sometimes they don't. I have not noticed a pattern to when they work or not work. I tried searching the forum for threads and did not get any hits. If someone can...

There is some oil leaking from the head gasket. I do not see oil in the coolant or coolant in the oil. Both are still pretty clean. I do see some water vapor out of the tailpipe on startup. My question is...can the head gasket be re-torqued down to tighten it up? Or am I looking at replacing...

What could possibly be leaking oil in the bell housing? I've replaced the rear main seal and the oil pan gasket. I also replaced the "O" ring behind the oil filter bracket. Someone on the forum a while back had suggested that could leak. Well...that "O" ring had hardened and was leaking badly...

My cherokee stalls 2-3 times after starting and then runs great. I have replaced the fuel pump, fuel filter, air fitler. The vacuum lines are clean as a whistle. I ruled out the ignition system because it runs great after warming up for about 2 minutes. Am I missing a sensor that tells the jeep...

The manual calls it a starter solenoid, the parts place calls it a starter relay. I think it looks like a relay. In any event, the jeep would not start the other day so I had it towed home. I tried starting it, and the red/black wire from the relay got so hot it melted the wire cover. My...

I have an 89 cherokee with a 4.0 engine. I read several threads in the forum about fuel pressure and regulators. Here's my problem...the jeep would start and idle, but stall as soon as the gas pedal was touched. I hooked up the pressure gage to the connection and it read 28 PSI with the...

I read the forum theads about changing over to R134a in my cherokee (89). I purchased the R134a quick connects. When I was getting ready to thread them on I noticed I did not have valve stems in either schrader valve from my R12 fittings. Is this normal? I woudl expect that my R134a will not...

So the brake pedal on my '89 cherokee goes close to the floor before stopping the jeep. So I read the forums and I replace the master cylinder. I go to bleed the brakes. I notice the bleed valve has been sheered off, so I replace the caliper. New master cylinder, new caliper, new fluid. I bleed...

I'm trying to replace the transmission cooler line on my cherokee laredo. I removed the entire line to get a better look at the quick connect. I see the 2 plastic tabs...now what? Any suggestions would be appreciated.

I have an 89 cherokee laredo. I replaced the power steering pump (brand new) and I pressed on a pulley from a pump that I bought on Ebay. I have shredded 2 serpentine belts so far. Question #1 Is a new pulley the answer? The second shredding slashed the transmission cooler line and it...

I have an 89 cherokee 4.0 liter engine. a few weeks ago I replaced the gasket on the oil pan with a friends help. Everything went fine exept that I was worried that the rubber seal at the back was pushed out toward the flywheel. Sure enough leaked like the Exxon valdez. Round 2 was today with...