signal works, but hazards dont

[johnny7point0]

This baffles me:

Both turn signals work (left and right) but when I put on my hazard lights, the right front signal doesn't flash.

This is frustrating me because I have to get an inspection sticker by the end of the month.

Any input would be appreciated.

 

[XJNick]

Need more info...

So, all the lights flash except the front right one? If so, it could be a bad bulb socket.

If none of the lights flash for hazards, might be a bad hazard flasher (some jeeps have a separate hazard and turn signal flashers).

If only one side is flashing for hazard, could be a bad contact in the turn signal switch...

-Nick :!:

 

[jps4jeep]

If you need a sticker, I can get you a sticker. do you remember steves friend that went to the jeep rally? he does state inspection. as long as the safety things are alright, he will look pass the bad flasher.

To fix the problem...hmmm

So all directionals work and all the lights work with the hazards except the front right? this is extremely baffling. from the flasher it is a single wire that connects to all the lights, in theory it is all or none.
Check the bulbs ground.
It could possible be a issue of corrosion in the socket for the ground. or even the pos. but I am leaning towards the ground. Use a Multi meter and check for 12 volts, then set to continuity and test the socket against a clean grond.