98 zj controle arm adjustments

grg98zj

New member
ok just got a 3 1/2 inch lift .all 8 controls arms need adjusting.is there a formula for this or correct uppers and lower adjustment measures or a process. I need help so any one please help.even if i need to go get a correct book.
 

Here is a video from Quadratec



Regards,
JPNinPA

Sent using TapTalk
 
perfect.Just perfect.this is exactly what I needed to get it done.this video explained it all and showed it.this was GREAT help.JPninPA thanks a million.
 
Just understand the driveshaft angles you need for the joints and shaft you have.

There are some other tips for setting. When I find them ill post up.


Sent from my iPhone using Jeepz.com mobile app
 
thanks any more tips would be greatly appreciated. hey another thing I'm worried about is how long the uppers and lowers should be on a 3 1/2 lift.front and back.im reading fir that height stock length is a good starting point until I get to the alignment shop.
 

Just reading this. Trigonometry. The length of one side stays constant. Control arm mount to point above axel on frame. The hight from axel to frame increased by 3.5 in
Old
x2 + y^2 = ca^2
New
x^2 + (y+3.5)^2 = (ca+n)^2

CA = old control arm length.
N is how much longer than stock.
This should be close


Sent from my iPhone using Jeepz.com mobile app
 
Back
Top