1. Slave Cylinder Plastic Pivot

    Replacing the slave cylinder on my 1985 Jeep Cherokee. Pulled the external slave cylinder, new slave cylinder does not have a plastic pivot on the end of the slave rod. Ordered a plastic pivot, my question is how to attach the new plastic pivot point to the new slave cylinder rod? Thanks

  2. #2
    Join Date
    Feb 2009
    Location
    Dayton Ohio Area
    Posts
    5,325

    Re: Slave Cylinder Plastic Pivot

    Sorry to delay my response. I did some digging and cannot find a diagram or explanation.
    Hopefully someone here has done this.


    Regards,
    JPNinPA

    Sent using TapTalk
    "Never look down on anybody unless you're helping him up" - Jesse Jackson

Similar Threads

  1. Slave Cylinder
    By JB88Cherokee in forum Cherokee, Commander, Wagoneer and Liberty
    Replies: 2
    Last Post: 05-31-2012, 07:56 PM
  2. slave cylinder
    By TheOKCAggie in forum Wrangler and CJ
    Replies: 5
    Last Post: 08-20-2011, 11:33 PM
  3. slave cylinder
    By Ragtopman in forum Wrangler and CJ
    Replies: 1
    Last Post: 11-07-2006, 07:21 PM
  4. Slave cylinder
    By odjeep in forum Wrangler and CJ
    Replies: 7
    Last Post: 01-20-2004, 12:28 AM
  5. Slave Cylinder?
    By laneiac in forum Wrangler and CJ
    Replies: 4
    Last Post: 09-09-2003, 07:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in