Factory Driving Lights

[southtj]

Is it possible to replace the factory driving lights on the front bumper with a brighter off road light and use the same wiring, switch etc? Has anyone here done this?

 

[avyoung]

Should not be a problem. Just switch the wire over. unless they use cheezy wireing for the factory lights. Check the gage and if it checks out just adapt them in.

 

[Green97TJ]

Yea, if the wiring is heavy enough to hold up you should be ok.
I have read of people putting 100w bulbs in the factory housing. They say it makes a huge difference. But since i have absolutely no personal experience with that, id try to read up on it before i tried it if i was you.

Nathan

 

[phatyaspen]

im running a set of hellas off of the stock wire harness....so what ever you want to run go ahead.Just cut the wires and splice them together and dont be scared to buse a lot of electrical tape and a soldering gun, thats what i did and my hellas ran fine until i ripped the wires out of the back of the lights :roll: aight man let me know what happens...

 

[jps4jeep]

If you don't feel safe about it, just wire in a seperate relay for added protecting.