If your Jeep sees a good amount of 4x4 time then you’ll most likely have to replace your front axle u-joints at some point. I replaced the u-joints in my 2005 TJ (with a Dana 30 front axle) after 115,000 miles, and they likely had some life left in them. It isn’t a hard or expensive process, so if you have any question about the condition of your axle u-joints then I would suggest changing them out.
If your axle u-joints are really bad then you’ll be able to see some slop in them when you spin your tire forwards and backwards. Mine were not this bad – I noticed something was up when I went offroad and got a loud and annoying “squeak, squeak, squeak” from the front end the entire time I was in 4wd.
Replacement parts:
I replaced my axle u-joints with some Spicer 5-760X U-Joint Kits that I purchased on amazon. At less than $25 per u-joint the price isn’t too bad. Here’s what a new axle u-joint looks like:
![wrangler_axle_u-joint_replace_01.jpg wrangler_axle_u-joint_replace_01.jpg](https://www.jeepz.com/forum/data/attachments/17/17666-00fd54ccdb3706463951bf80653a8daa.jpg)
Replacing the joints.
If your axle u-joints are really bad then you’ll be able to see some slop in them when you spin your tire forwards and backwards. Mine were not this bad – I noticed something was up when I went offroad and got a loud and annoying “squeak, squeak, squeak” from the front end the entire time I was in 4wd.
Replacement parts:
I replaced my axle u-joints with some Spicer 5-760X U-Joint Kits that I purchased on amazon. At less than $25 per u-joint the price isn’t too bad. Here’s what a new axle u-joint looks like:
![wrangler_axle_u-joint_replace_01.jpg wrangler_axle_u-joint_replace_01.jpg](https://www.jeepz.com/forum/data/attachments/17/17666-00fd54ccdb3706463951bf80653a8daa.jpg)
Replacing the joints.
- The first step to replacing your axle u-joints is to pull out the axle shafts. You can see how to do that in a previous how-to here.
- Next, you’ll need to remove the clips that keep the old u-joints in place. You don’t need a special tool for this – I use a wood chisel, but I’ve seen others use pliers. The idea is that you just pop off the clips. The clips actually come out quite easily.
- Now, we’re going to drive out the u-joints. There are a couple of ways to do this. I decided to support one half of the u-joint, then hit the other side with a hammer, in a downward motion. You can see in the photo below that the cap has popped out of the axle.
You could also use a vice to press out the u-joint. Just put a large socket over one side (the u-joint will pop out into this socket), and a smaller one on the other side to press the u-joint in. This method of using sockets will also work by just using a hammer to pound the caps out. - Once you have the old u-joint out, you’ll need to put the new one in. You’ll want to remove the caps from two opposing ends of the new u-joint (keep track of what cap goes where – they are machined specifically for that spot, and shouldn’t be mixed up). With the caps off it will easily fit in the yoke. Then carefully put the cap on one end, and tap it into place with a hammer.
- Then do the same for the other side.
- Remove the other caps, and do the same as before, putting one cap on at a time.
- Finally, put the clips back on. These actually go on quite easily with just your hands.
- Reinstall the axle and you’re done.
Last edited: