colossus68
New member
I need assistance. Can anyone assist me. I have a Jeep Wrangler 2005 and I would like to know how to remove the inside door paqnel. If any one know I would be appreciative.
Scott (Colossus)
Scott (Colossus)
door panel
- Thread starter colossus68
- Start date
colossus68
New member
My Bad! It is a full door.
JPNinPA
Active member
Used this from another site. Worked
There's a clip on the backside of the window crank, pop it out with a small screwdriver.
Remove the screws on the pull handle.
Remove the screws on the edge of the door panel.
Pull the door panel outwards at the bottom to clear the window crank shaft, then slide it outboard (toward the latch, not toward the hinge) till it clears the little triangle in the corner of the window, and then lift. It will sort of unsnap from the top edge of the door.
Installation is the reverse.
There's a clip on the backside of the window crank, pop it out with a small screwdriver.
Remove the screws on the pull handle.
Remove the screws on the edge of the door panel.
Pull the door panel outwards at the bottom to clear the window crank shaft, then slide it outboard (toward the latch, not toward the hinge) till it clears the little triangle in the corner of the window, and then lift. It will sort of unsnap from the top edge of the door.
Installation is the reverse.
Similar threads
