Recent content by 05renegade

Updated photos of my CJ

Updated photos of my CJ

I'm not the most knowledgable on this, but you should be able to test the low circit (both voltage and ohms) on the coil with a multimeter. I did this on my 82 cj and it saved me from replacing something I didn't need to.

its just the casing.....

I didn't adjust the floats only because I really didn't know how to, and i didn't have a reliable means of verifying the distances that Weber recommended. The floats themselves were brass. When it first starts up, the engine "chugs" and there is some blueish/gray smoke that has the...

The first tubes that were clogged were the tubes leading to the top of the butterfly valves. I access these when the carb was apart. I first tried shooting cleaner up through them and nothing came out, then all of a sudden fluid shot through them. I thought these were the idle tubes. Then...

Here are some photos:

I have a metal plate with Weber stamped on it along with some numbers....nothing that resembles model numbers. This plate is attached to the screw next to the fuel inlet tube. At the base opposite of the choke there is a stamp "Italian" but no model number. With that, I assumed it was a...

OK, the rebuild is done - overall the carb looked very good however the idle tubes were clogged, but not anymore! I put the carb back on last night. It started and idled pretty good today. i had to shut the engine off, and now it won't fire :lol:. I definitely think I made some progress, and...

WOW thanks for the information!!! I'll give you an update when I can!

Thanks Rubicon, I'll pick one up the next trip to the parts store....for now, I am calling it a day.

now if I take the air cleaner off it dies .... I have to laugh!

I messed around with it some more...adjusted the choke and now it definitely runs smooth while cold, but as it warms up it starts to run rough and die. Yeah I want to try anything and everthing before tearing into the carb! I'll continue to mess with it you have any ideas send them my way...

I want to say its a 32/36 DGEV, but I can only go off of pictures, It was installed when I bought it, and I have no documentation. It has the electric choke. As far as the timing goes, it was idling but at a higher than normal rpm...about 1100. I realize it's not the right way, but I was just...