Recent content by 67bbc

Do you know where I can find the id numbers on the rear housing? I am trying to find out if my 91 YJ has the factory trac lock rear or not. Want to get a powertrax locker, just want to make sure I get the right one.

1066144 Oops! My bad! It is a 91 YJ 2.5l 5-speed. TPS was changed, no luck.[addsig]

1069634 I changed the fuel filter, idle control valve, nothing better. It is the MPFI. I will try cleaning also and see if it helps. Thanks for the advice and if you can think of anything further let me know.[addsig]

1064672 Thanks for the reply. I tried your suggestions and I also re-installed the old O2 sensor but no good. Still barely runs. Do problems with the MAP and Crankshaft Position Sensor cause this?[addsig]

1064727 Not taken the wrong way...freebees. Can't beat that if I can use them.[addsig]

1064970 It is Fuel Injected.[addsig]

1064656 I had a bad muffler and changed it today. While I was at it, I figured I would go ahead and change the Cat conv since I was done there along with a new O2 sensor. My problem is after I installed this the wrangler idles at 1300+ rpm's, then drops down and tries to idle around 600 rpm's...

1064697 I have to replace the hood on my YJ and was wondering if a CJ hood and grill will work? Do I need to get CJ fenders also?[addsig]

1064870 I just installed a pacesetter header on my 91 YJ, 2.5l. Fit and sound good, for a 4cyl. Anyway, having a problem I need help with. The engine now idles around 1500 rpm's and at around 3500 rpm's and above it seems to load-up/stumble/miss bad??? I triple checked to ensure the...

1064948 Another problem...does not idle below 1500 and stumbles at/does not go above 3500rpm's???? Any ideas??? Could not find a vaccum leak and has new distributer, wires, plugs, cap and rotor???? Is it possible that it could be the ignition control module? I am running out of ideas and...

1065482 My clutch just went out yesterday and needs replacing. Are there any recommendations to replacement parts? Should I do it myself or have it done? Is the slave difficult? stock/aftermarket/performance parts? It will be driven on the road primarily 95% of the time? Your assistance...

1066046 ok, ichecked my vaccum lines and they seem to be alright, but it still idles around 1700 rpms. Any ideas? :-? [addsig]

1066047 It is hard to get in gear and when it does it engages when I release the pedal only a little about 1/2 to 1 inch. Did not give me much notice, worked fine now it does't. Usually when a clutch goes on me it just slips with no engagement. Is the problem in the clutch or transmission...

1066048 It is hard to get in gear and when it does it engages when I release the pedal only a little about 1/2 to 1 inch. Did not give me much notice, worked fine now it does't. Usually when a clutch goes on me it just slips with no engagement. Is the problem in the clutch or transmission...

1066424 I plan on replacing the clutch this weekend with a LUK clutch kit with slave...are the any recommendations, tips, or advice...I have not done a clutch replacement in about 10 years. Your help is greatly appreciated, I only want to do this once and have it done right the first time...