I had to get my part from the dealer.After you install the new part if it doesn't blow very hard then reverse the 2 wires going to the motor. You will be able to pop the pins out on the connector that plugs into the circuit board. I think the wires are red and black,if you trace them to the...
Ok,I'm freaking out. I had a whining noise and then found my power steering fluid had completely leaked out at the connection of the high pressure cooling hose and the power steering pump. Now I just found an article saying the it can cause severe engine and coolage fan damage...
I tried to tighten the end of the coolant hose that is leaking.It is as tight as it will go. It feels loose, it has play in it. Is there a gasket or something that could have deterioated making it loose?
THe pic on the left is the connection that is leaking, about 4 o'clock from the yellow...
4.7 v8 engine I just posted photos in my gallery. One is a pic where the leak is coming from it looks gold because I was pointing the light on the leak. The other is the hose that is connected at the leak. It is metal on the ends.
OK I not the transmission unless I have 2 bad problems. I pressed the gas sitting still in park and it made the same noise as moving so I guessed not the trans, but I was able to check underhood today,no storms like yesterday and found that the power steering fluid has totally leaked out.It...
2003 grand cherokee v8 Ok, maybe I have just noticed this. Something is making this loud whining noise. Sounds like a jet engine reving up kind of, except it doesn't sound like the engine.
It speeds up when I do. Is the transmission going?Only 60k miles on it. Any ideas?
2003 cherokee, code0455 large evap leak, replaced gas cap,checked what I could find of hoses. I have a weird slight knocking/tapping noise coming from the area between the gas cap and the rear bumper when the truck is running. Could this be causing the light to come on? Should I be worried...
I just wanted to thank you for posting this. I used the retrofit kit a few weeks ago and the blower had been weak ever since. I was contemplating installing a new motor, but it didn't make sense so I was trying to find an alternative solution. I switched the pins and now all in the world is good!