Recent content by BobJ

at 20 years old you main gain some extra height by replacing the stock springs as well. if you go the home made route by some stock replacement springs and use your old ones as AALs.

360 V8

it's a '89, so SJ. thanks.

How much would I need to lift it to fit them? TIA

1043519 Sounds like it could be the spider gears, does it jerk at all? Do you remember hearing a loud(er) pop/bang noise lately? Get some gear oil and black silicon, take off the rear diff cover and change the fluid just to be sure there's nothing wrong in there. Hopefully you wont find...

1043520 4.5" Long Arm, 1" Body Lift, some engine mods, SYE/CV drive shaft, full cage, bullet proof rear swing out, arb bull bar and warn winch up front, 34" Trxus. Adding a D60 rear some time in the next month along with beadlocks and run flats, possibly a new t-case.[addsig]

1043521 unless you have the auto there is nothing different about your jeep (except the interior) from an '00 to '02 model [addsig]

1043522 Yunalesca my Jeep summons one heck of a beast (gotta be a final fantasy nut to get it )[addsig]

1043523 what year is your Jeep? Either reverse doesn't have a syncro or the syncro is broken. if it doesn't have a syncro putting it into 1st gear 1st should help like said. has it always done this?[addsig]

1043524 The Jeep Owners Bible might be a good start, you can probably get it from amazon.com[addsig]

1043525 5.5" HTH[addsig]

1043526 helping disconnect the sway bar will help, you can buy a set of disconnects, or you can make your own in a couple of ways such as drilling out the pin on your sway bar and replacing it with a hitch-pin. YJs do have track bars, most people just remove the rear, it's there for road...

1043527 $29,847 is expensive for a rubicon. Unless it's an Auto and has an aftermarket lift. there is still no such thing a Jeep with "factory lift". It has lots of problems and lots of flaws, basically if you think about it, if you were to purchase a sport close to invoice, and buy the...

1043532 it's in the front. the sway bar is U-shapped, botton of that U goes in front of the grill. From the ends of the U the sway bar links connect from the sway bar to about where the spring meets the axle.[addsig]

1043541 never got the private message. I busted the spider gears in my differential, had it fixed under warranty, what you describe sounds exactly like that. If it's not under warranty it will cost about $300-$600 depending on if it took anything else out with it. What happens is when...