Recent content by brian4.2

Got it on both the TJ and the LJ. Tough and out of the way.

Who said the 49rs suck. They're in a slump. You brought up football in your 1st post.

Yuh , Battle of the basement!

Stock transmission mount. Get the yoke from John @ JB conversions, he will know what you need.

I've done this job with that lift and that Tcase. You have to beat the inside of the tunnel to get the clearance. I used a 5lb. sand hammer, worked great. I think you should read this install stuff. Its a 241OR Roc-Trac. I have the install manual from JB conversions if you get into trouble...

I've reset tractor tires with ether. It is the explosion you are looking for. when you have a 5" gap between the tire and the rim and a 5 ton tractor sitting on it, well there is no way to muscle it any closer. It is daNGEROUS, stand away from the opening, use a long candle (something you dont...

Yep, goes with the TJ. All the parts are the same.

Picture an unlimited on 37s with a 6" long arm suspension, doesnt look goofy in my mind, just a growed up scrambler.

Great temporary driveshaft, excellent work. Beware of prolonged use at highway speeds.

OK just to add to the general wild posting here. I just saved a bunc.... no atually I bent my TJ drag link up pretty good on the Rubicon and replaced it with the Currie HD drag link. This thing ROCKS1 All I gotta say is if I bend that monster up I going to have some sereous problems elsewhere on...

We had a hard time getting those parts for Sully's jeep, dealer screwed around for weeks. finally ordered them from quadratec. Its the 20 gallon unit be sure to order the filter, its extra and not listed in the catalog.

We have an Unlimited in the family. So we needed a pickup at work to do the small deliveries, a "gopher mobile" The gas hog stake bed 3500 gets about 7MPG if you baby it. We were looking at Titans and Toyotas and that kind of truck, guess what followed me home? Hardtop ,kaki,Unlimited! its kind...

Its got a Jeep Vin. #

When they say clean the battery terminals, they mean CLEAN, use a wire brush or rough it up till it shines new metal with sandpaper.

Uh OK you got me. Put spring air in there till June.(unless you have some summer air around) Track bar front and rear. This is what aligns your axles to center. Its actually OK to have the rear off center a little but not the front. Picture would be great. Now what about a lift? do you have...