Recent content by Dixie Dog

Yes. I will try to get you pics. Will you sed me your email address? Thanks for the help.

When i say its bottomed out i mean its stretched to its limit. It does go back together but its just the bushing in the sleeve. There is still about an inch for the bushing to slide into the sleeve. There is nothing for it to hold it from just being able to turn the wheel and the wheels doing...

Yes, the steering shaft. Thats what im reffering to. What do i need to do?

I have a 90 with 4" sus lift and 2" body lift. Recently mt steering arm came loose. Trying to get it put back in it seems to be to short. It is bottomed out as far as length goes. Is it bc of the body lift? What have yall done that have body lifts?

What other vehicle has a rear seat that i could replace mine with? That will fit instead of buying a new aftermarket one.

I will check the coolant level. I just drained it bc I had striaght water in there after i replaced the water pump. Wanted to make sure the water pump was working before i put the coolant in.

Why does my heater blow cold air while im not moving? When i am moving it blows warm but not real hot.

This may be a dumb question and if it is im sorry but where in the world is the trans dipstick so i can check the fluid. I swear i searched for it yesterday.

Thank yall. I was just wandering bc i believe it has two sets of plug ins. Mine is conected on the right side to a harness but the other set of conectors has nothing on them.

Can someone tell me where to find a diagram of this. Where what plugs in and everything before i go to pulling it out.

Anyone ever used the xenon fender flares? Im thinking bout putting the flat 6in on my yj.

any ideas?

Wanting to install an amp in my yj and dont really know where a good place to mount it. Any ideas? Where do yall have yours mounted?