Recent content by fishskuller

I replaced the pulley and the serpentine belt still rubs against the engine. Though it only rubs when the engine gets warmer. The pulley lies between the crankshaft pulley and the alternator and holds the fan clutch. If anyone knows why this happens or has a similar problem please help me. Would...

My Idler pulley was replace a year or two ago, so i think that's Ok. My fan clutch is not attached to my water pump. My fan clutch is attached to separate pulley under the Idler. The belt is not lining up on that pulley holding the fan clutch and it rubs against the timing chain cover. I can...

The serpinetine belt seems to be drifting off the fan clutch pulley and rubbing against the timing chain cover. What would cause the belt to be slowly drifting off the pulley? I think this is what sounds like a bearing making noise. How would you fix this problem? Please help me!!

(1) 39.5 x 15 x 16.5 TSL for a spare I just put a new water pump on and a brand new belt and it still makes a sound. I've noticed on the timing cover it looks like the belt was rubbing against it. I can't seem to get the belt to stop squealing. So i put the old belt back on and now that one...

replace the fan clutch if it keeps overheating. I had the same problem.

Hello everyone, my problem is my 89 cherokee L6 4.0L has a noise coming from the grill area. This noise comes and go's and go's loud and could be quiet at times. Either way i know it's a problem, but the question is "How Big of a Problem?". I changed my alternator thinking the bearing was shot...

O2 was replaced 5yrs ago. it seems like the timing is off, because when i moved the distributor a hair the o2 sensor read fine and the jeep ran lean, TB is a little dirty. Is there any special way to clean it without taking it off? i'll guess i'll check all the wiring again also, Thanks alot for...

89 jeep cherokee L6 4.0l has been sputtering up hill on accelerating and failed inspection for carbon monoxide level.so i put it on a diagnostic tester and all the sensor's were going wacky.it was running from rich to lean. All the wires and plugs are good, so i turned the distributer a hair to...