1058111
i come from r.i. the ocean state and anything that even smells salt rots. sorry. just keep doing what ya doing and ya might even think about brushing some of that chemical that turns rust to black like primer. just in case .[addsig]
1058116
as far as the frame goes really look around the rear leaf spring perches and on either side of the gas tank. as far as the difs ,trans, and engine goes your v.i.n. should have all that info. id try to get it for 1500.00 as you probably wnt to modify it somewhat for the trail.[addsig]
1058119
ot sure what kind of ride ya driving ,but if its a cj check the leaf spring u bolts. when they get loose its a hairy ride axle doesnt stay in position :-O [addsig]
1058131
i received a hard top with some fiberglass damage in rear corners. repaired and i am not abody man so it didnt come out like glass or perfectly straight. i roughed it up with sandpaper, and hit autozone. they have a spray on bed liner for truck beds in black and i used that . it came...
1058320
very funny. kind of sad though. whats it gonna take before people figure it out. nuked its easy to protest what hasnt happened to you,but lets here from all the innocents in New York and their survivors. [addsig]
1058324
hi Sammy bummer about jeezer but they bounce right back. almost everyone gets some battle scars,youll fix jeezer back as good as new in no time. I hear ya on the springtime thing. Had it with snow for now.[addsig]
1058326
i run a ri inspection station, but we have more than 1 store. i asked the mass inspector and he said there is a measurement taken from bottom of door to ground. i have seen 33 inch tires and 4 inch spring susspensions pass inspection. tires can be a hassle as he said only 1/2 inch is...
1058618
i have located a magazine strictly for jeeps. its called JP Magazine. i believe it only comes out every other month but there is so much info and sites to buy from or go to via puter. i have found it mostly at walmart and sometimes borders books. so this helpsya.[addsig]
1058623
i researched the LockRight and i havent put one in yet but appears straightforward. it doesnt need any calibrating or special tools to do the job. takes maybe couple hours max.[addsig]