Recent content by jlynn33

Did not replace the map sensor yet. I will drive it this week and see if it changes.

Cleaned out DTC and still idling at 1050 when warm but much better. Drove it around and it SEEMS ok but still think it should idle at 900 like it use to. Any thoughts?

Definitely cleaned out iac housing when attached to new throttlebody (used brake cleaner and ragged it). Checked for vacum leak with brake cleaner....nada. Throwing DTC now of P0108. Why a map sensor code now?

I replaced my original throttlebody (which is a modified that had been bored out to 62mm) on the advice of a mechanic I took it to after trying the tps switch and cleaning my existing iac did no good. He thought it was worn out because it would not close with the cable off but you could manual...

Before I put on the new throttlebody I could put it in park and rap the throttle to get it back to idling normally but can't do that now. So no, I do not think it is a wire around the pedal but I will check today. Thanks.

Replaced throttlebody, replaced idle air control valve, tried a new throttle position sensor first but did not disconnect battery. What next?:???: