Recent content by pghpenna

RE: I found a place finally! I got one for my gals 93 yj from Quadratec for $129. I dont't know for sure if they carry them for the 97 tj but I don't see why not. Frank

RE: new here, howzit No takers after a week, They will be 86ed this evening. I'm not in the habit of wasting but these panels are taking up space at the abode, Only sorry a fellow jeeper could not use them.Frank

RE: Re: RE: Starter problems, I think. . . Ive got a pair of inner door panels for a 93 yj that I'd like to give to a person and not the trash can. These panels were painted black and kept peeling so I replaced them with a new pair. With a lil elbow grease and some dye/paint they should be...

RE: Do YJ half doors have locks? A cohort at work has a 91 yj with 33" tires and wants to know which would be a better caliper... phenolic vs metal piston. Any comments please. Frank

I opted to diassemble the pin from the spring and turn down the pin on a lathe in case I ever wanted to go back to the origional springs so I wouldn't have that extra 1/16" slop. I guess you could always machine a bushing if you decide to go back to the origional springs. Just my .02 cents. Frank

I got a new tailgate, windshield frame and necessary gaskets/moldings for my gals 93 yj. She would like to have the new parts installed asap but we are not planning on painting the jeep until this spring or summer. Will the protective coating/paint hold up or should we get these two pieces...

Yeah, I guess the Ravens have a good chance of beating the Steelers seeings how they will most likely be playing their second string to avoid injuries. Frank Go Steelers

I put a Rough Country 3" lift on my gals 93 YJ 5 speed 4.0 last year and I am starting to get some terrible spring wrap. At first I thought it may of been the U-joints so I replaced and greased them up to no avail. Seems every time I try to duplicate the noise with someone with me it wount do...

How about them Steelers! I've been waiting for one for the thumb since 81. Not to rub the NE member base the wrong way I hope this year might be the year. I've lived in two foreign countries and numerous states but no matter wher you go in life you have to remember where you came from. I am a...

It's a Jeep thing... well, I guess you understand Seems my gals 93 YJ does have the AX-15 and not the Peugot transmission as you all told me. About 1 1/2 years ago we had the trans rebuilt and the mechanic told us it was a Peugot transmission. Using the boards wisdom and Inspector-Gadgets link...

no sir, its fuel injected. Frank

You are correct sir. The engine is a 4.0L 6 cylinder with the Pugeot trans, dont know if there is a special bell housing to accomplish this feat. Frank

TJ speaker wiring Had to have my gals 93 YJ towed home this weekend, I think it has a bad slave cylinder (see previous post). The jeep has the dreaded Pugeot trans, I know the ax15 should be with this year but my gal fried the engine a few years ago and had it replaced. I think the mechanic...

Had to have my gals 93 yj towed home this afternoon, Its a 4.0L manual trans. The clutch is stiff and there is fluid in the master cylinder, but after the engine starts the clutch goes limp and engages a lil bit just above the floor board. Is there any vaccum lines associated in the design or...

I had about the same problem with my gals 93 Yj, it turned out to be a disconnected hose from the two roll over vent valves on the gas tank. If you take your gas cap off a few hours after driving and don't get a hiss this could be your problem. Frank