Recent content by Rollbar

My son and I swapped out the old tired points driven AMC 304 & Installed a AMC 360 with electronic ignition. Our plan is to hook up the wires (we marked locations etc) and then see what we need to do to incorporate the ECM Dist into the system-tap the ECM into the '74's system. Anyone have an...

:)

CJOFFROAD.ORG

Thanks, I added your I-6 Team Rush to another forum cause the guys R having problems. Hopr U don't mind, I just copied/pasted word for word w/the same title. Jim

Does anyone have the size of these two bolts that fit the frame on a CJ8. The left hole is smaller than the right hole in the frame. No worries, I can drill/tap if need be. Just would like to know.

Never mind - got it/know how to clean it out. Thanks, The fluid came out a little rusty but clean. P.S. Don't blow on the P-Valve when U have something like this. Wait, that didn't sound good.

Yes I am, I have the SS lines from In-line tube. Just want a brake line that would equal a 4" lift for future if I do go that route. I also need the three way on the rear axle as well. I'm 2.5 w/a 1"BL on my CJ8 build.

How do U clean the valve when it is not on the Jeep, OR, should U install everything & then force fluid through it (i.e-bleeding brakes). Here is the valve off the CJ8 to M170 build. PO, cut the old lines & I just broke them free. Now, to me, since he cut them, it crimped the tubing so it...

I just replaced the T-out bearing in the Peaches CJ yesterday. The CJ is different than some of the yJ's. Easy to do, just took time. On the CJ model, leave the skid plate in-tack, remove the bolts (w/the proper jack supporting it) & slide everything back as a unit, works well & lines up...

I had a link to a site that is no longer available. Looking for a set of brake lines to meet a 4" lift for the CJ8. Stock rear drums & front calipers. I can't remember but I was thinking that a early Ford bronco would fit. Not sure. Any help would be great. Thanks,

Thanks JH. I have had the MSD6 on my '79 & loved it. When I got married long ago my wife car (Buick) had the module in/under the dizzy if I can remember & it would get hot, needless to say I ended up changing out three before I got ride of the car & that was back in '81. I hated to get...

Thank you, I finally got the answer I've been looking for. I have #1 but will upgrade to #2. In the mean time I will use the stock until I can get to NAPA.

'74-80 360 v8 321 2653 This is axactly what I need for my build. Now I just need to find one.

OK, ? I've heard that the stock ignition module needs to have a capacitor added or something.....in line or it will burn up eventually from the coil. Is this true? I have all the parts but have not installed due to this reason. I have heard of people being stranded because of the stock module...