Recent content by ronpapworth

Interesting. So there will be no codes if the check engine light isn't coming on... makes sense! yes, you are correct, I went through it when I got the Jeep last November and did plugs, cap, rotor, wires and all the fluids, and of course air filter. Is there a gasket I need to get before I...

Tested the milage a couple times. She is getting right around 11 MPG. Sprayed out the throttle body that was pretty gunked up, but can't really see into the air regulator port on the side of the TB. I am assuming the is some sort of wire in there that may need to be cleaned better? Pulled the O2...

1065003 I can weld, but not upside down and that close to the gas tank! Thats not a bad idea though. I'll try my bolts first and then take it to a shop if they don't want to hold.[addsig]

1065006 The mount has about 1-2 inches of space from the floorboard to the mount holes. Another good suggestion with the longer bolts. The carpet would cover them up...[addsig]

1046986 Well I got it done this weekend. Man what a pain. First off, the dome light housing in the middle of the speaker is POP RIVETED! into a plate that is glued to the roof. So you have to break your car to get the whole unit down. You can cut the pop rivets(one is longer than the other)...

1047198 nah, the recess in there is pretty deap at the angle they set the speakers at. I had at least another inch of room! Ron[addsig]

1046164 Hi all, Great board you have here! Looking at a 94 Cherokee Sport and wanted some input. I am buying it from a private party and they are the original owner. The dash light is out of it and it just started leaking oil(they say). I am sure I can find the oil leak,but how hard is the...

1046721 How do I get the speaker/light housing off the inside roof to replace the speakers? The grills come off, but the factory speakers appear to be pop rivited in with plastic fasteners. I could musle them out of there but I am not sure how to affix the new speakers without getting to the...

1064999 Well it appears that the 2 upper bolts that hold the rear shock on became one with rust and the mounting threads as both of them sheered off when I went to remove them. Spent most of the day drilling and trying to extract the rest of the bolt but they never did come out. I have...