Recent content by snodog

Thanks, much appreciated

I'm new to the jeep thing, I have a 97 4 cylinder I need to tighten the belt and for the life of me I dont see how to tighten it. The alternator dosnt seem to have a slide bracket. anyone? TIA

the heater box apparently has a vent or door inside controled by the temp. switch not the one by the passenger door,which is causing a no heat problem. There is a lever controlling that door that is broken and was told its not sold separatly and that I need the whole heater box assembly. I was...

RE: Re: CJ seat Bracket Assembaly? Does a heater box assembly contain the "mode" door or vent as I know it. The lever on there is broken thus no heat, and was told I need the whole heater box assembly. TIA

CB ???? Since my last post project completed. I removed sway bars,track bar at axle, the only problem was I didnt get enough drop so I took a bottle jack and lifted one end of axle to get other end to drop further springs went in with a little help from a crow bar,piece a cake. Thanks guys for...

RE: 2 sets of axles 4 sale Yeah I planned on that, how badly does it get thrown off?

Thats what I thought. lower shock bolts,sway bar end links,track bar at the axle. Everything should drop from there. Instructions that came with spacers as well as Haynes manual says to disconnect both tie rod ends. That didnt seem right to me hence my post. thanks for the info.

Update (wheel alignment) Manual says disconnect tie rod ends, is that necessary? I'm putting in coil spacers.

RE: Steering problem after stuck, HELP!!! Anyone know of a link for tj front spring installation. I have a haynes manual but it only shows leaf installations. basically I need to know if tie rod needs to come off both ends. I know track bar, sway bar link needs to be removed. drag link?

RE: Re: RE: Re: RE: 2006 or 07 Redesigned Wrangler Yeah, I agree its could definetly be a vaccum leak or pinch in the line somewhere I really do need to trace everything out,its just so damn cold out (VT). I appreciate all the suggestions and info and everyone who chimed in. let you guys know...

Flaps are closed,no draft just wont blow hot only luke warm. To recap luke warm heat only through dash vents wont blow through floor or defroster. What Ive done- checked all vaccum lines/connectors,temp cable is fine, all flaps are closed,all fuses ok. everything as should be. I'm stumped. Just...

RE: Daily Driver 87 YJ Rust - Fix it? Radio has been out. Positively no vaccums/connectors are disconnected, Ive traced back everything everything looks as should. I'm almost convinced its the heater control assembly,with that being said has anyone replaced theirs because of any problems.

Thats what Ive done, Pulled on the arm at the end of the cable,still only luke warm. Eyelet is in its place,my main concern is no defroster only blows through dash vents.As far as heat goes I'll have to go for the obvious,thermostat. if that doesnt work I'm going to get a new heater/ac control...

RE: Am I losing it? That was the first thing I looked at, the wiring/connectors are very sraight foward. everything is in place. The odd thing is with engine off you can hear the different vents opening and closing as I slide the lever. But not when blower is on.

Didnt see any flap on the passenger side.I have a 97 tj if that helps.