Recent content by stiggity

1043853 wms to wms is 55 inch. I did'nt mesure the drums but they look like 11 or 12 inch. The bottom of the drums is pretty much level to the bottom of the center section. What do yah think of the 16 spline axle's compared to 30 or 35 spline. I have a dana 44 out of a scout and the axles...

1042693 Yeah: I am pretty sure the Dana60 will not bolt right in. As far as fabricating the rear-end too fit into my "truck", i have a MIG Welder, O/A Torche, and the rest of the "goodies" to install the rear. I guess my question should have been more along the lines of, Have any of the...

1042637 Greetings All: I have an '86 Comanche 4x4, 2.8, 5Spd I recently purchased a Dana60 Rear, out of a F250. Has anyone installed another rear in there Xj, or anyone know of any links to where i can get some more info. I know the housing is alot bigger, and im going to lose some...

1043835 Hi. I was wondering if anybody could answer a couple questions for me. I found a full floating dana60 eight lug I was considering sticking under my yj From flange to flange it's 55 inches long. The axles are 16 spline. I'm not sure what it's out of. It was just kinda of lying...

1044268 Hey, Was just wondering what you guys thought of the Rusty's 3.5-4 in lift. Also anyone hear of removing the front and rear track bars when installing a 4in lift on a yj. I know the cj's didn't come with any so I thought what the heck take em off less parts to spend money on and...

1044442 Supposedly the np 231 has a lower crawl ration then the np207. 2.7to2.6 I have an 86 comanche with a 207 30x9.50 tires and stock 3.55 gears. When i put it in 4 low it crushes my yj. I can't go over 15mph or i tack my motor out even in 5th gear. My yj is a 91 2.5 with stock 4.10...