Search:

Type: Posts; User: JPNinPA; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Thread: 2023 exhaust

    by JPNinPA
    Replies
    2
    Views
    54

    Re: 2023 exhaust

    I dont know. Sry



    Never look down on anyone unless you are helping them up - Jesse Jackson
  2. Replies
    2
    Views
    121

    New smoke from the tail pipe

    First verify if its burnt oil. White smoke can be CAT buildup, rich gas, steam from cold exhaust or head leak or burning oil.
    Look at your exhaust pipe. If black sooty buildup it could be oil or...
  3. Replies
    2
    Views
    196

    High pitched noise while driving

    Do you mean radio interference or more mechanical.

    Radio: Check battery connection and opposite end of the ground wires. The contact points should be polished. Wire resistance less than 1 ohm....
  4. Replies
    1,799
    Views
    889,286

    Re: What did you do to your Jeep today?

    If you havent yet do a fuel pressure test. Steady at 49 psi +/-2 at idle and 3300 rpm and after engine off. Once off the pressure Should hold psi for more than 2 min.

    Low fuel pressure.
    Weak...
  5. Replies
    6
    Views
    657

    Rough Crap-try shocks!

    Correct you want the springs to be the limiting factor. Avoid the limiter being the brake lines or shocks.
    If you have shocks for a 2 in lift and add 1.5 in spring spacers the shock will limit...
  6. Thread: Steering issue

    by JPNinPA
    Replies
    4
    Views
    2,505

    Re: Steering issue

    This is a bit old. But id check caster . Also check camber to tire height and width.
    Toe is important but if you have less than 4 -5 deg caster the scrub is under the center of the tire providing...
  7. Replies
    6
    Views
    657

    Rough Crap-try shocks!

    I have to ask. Was the shock matched to the amount of lift? Does he 4 wheel and disconnect sway bars?
    Shear indicates the shock was fully extended or received a shot with the force of an accident.
    ...
  8. Replies
    4
    Views
    315

    Re: Squealing belt on my TJ

    They use a <3 to indicate popular purchase. They used another mark for OEM equipment. Cant recall.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  9. Replies
    1,799
    Views
    889,286

    Re: What did you do to your Jeep today?

    Is it me or is your drag link at a different angle than your track bar??

    This leads to bump steer. Hit a bump and the wheel gets jerked out of your hand.


    Never look down on anyone unless you...
  10. Replies
    4
    Views
    315

    Squealing belt on my TJ

    Sure thats not your wallet screaming?

    Id change belt, tensioner and idler pulley


    Never look down on anyone unless you are helping them up - Jesse Jackson
  11. Replies
    3
    Views
    644

    Re: S.Jersey reputable repair shop.?

    Sry
    Check for local jeep clubs and ask where they go if they had to. Maybe the club has an expert.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  12. Replies
    6
    Views
    1,504

    P000A code help

    Maybe its time to replace it??
    I have a honda with a 2.4 engine the exhaust cam wears and galls. Every 30k mi the rockers need to be checked and regapped. Sucks had to replace the head. FYI
    Reman...
  13. Replies
    9
    Views
    1,083

    Re: Worst carb I have ever seen

    Carb going to dribble dribble you know.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  14. Replies
    9
    Views
    1,083

    Re: Worst carb I have ever seen

    My money dont Jingle! Jingle! It folds. .


    Never look down on anyone unless you are helping them up - Jesse Jackson
  15. Replies
    9
    Views
    1,083

    Re: Worst carb I have ever seen

    Yep force carb and choke cleaner through it. Does the float, float? Does the needle stop the flow? Rebuild kit $$14


    Never look down on anyone unless you are helping them up - Jesse Jackson
  16. Replies
    1
    Views
    789

    Transmission jumps out of oberdrive

    What size tires and gearing? All stock?

    Many write of this and rough ride/drivetrain. Check trans fluid. It could be the point the Torque Converter locks. Does it continue at higher rpm or speeds?...
  17. Replies
    8
    Views
    1,337

    Re: Does anyone know what this is?

    Carpet aligner.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  18. Replies
    2
    Views
    1,564

    Trying to get a 1998 Jeep Cherokee started

    Is the noise under the hood or in the cabin? There is a valve for HVAC that is in the dash in many jeep models that clicks as it moves


    As for starting. Gas air and spark. As noted start with gas...
  19. 07 wrangler, stalling at idle/traffic lights.

    Agree with The NSS issue after reading it only clicks when starting in park.


    https://youtu.be/_qGt-NsVWV4


    Could try this to verify. Dangerous!!! Needs to be in park
    Neutral Safety Switch...
  20. Replies
    6
    Views
    1,104

    Re: 2019 Wrangler Unlimited Sport

    Crawl under look for rust
    Aftermarket parts
    Take it for a ride to heat it up
    Go to a mechanic or auto store and look for codes and that the data is set. If not set they may have removed the...
  21. Re: 07 wrangler, stalling at idle/traffic lights.

    That is a lot of seafoam.
    Every oil change is good.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  22. 07 wrangler, stalling at idle/traffic lights.

    The stalling at a light can be a few things. Start easy. Clean your Throttle Body and the IAC. and the TB.
    Blow out yhe (TPS) trottle position sensor or at least work the butterfly valve 20-30...
  23. Re: Need Suggestions for Replacement Fog Lights for New Bumper

    Just a thought. Fog lights are to be a broad 170-180 deg spread left to right and narrow height to shine under the fog.
    If you mount fog lights in the back of the holes you will be cutting most...
  24. Replies
    6
    Views
    1,504

    P000A code help

    How steep is this mountain?
    How full is the oil?
    What brand oil filter?


    Here is something dug up with a 2 min search. Might be usefull
    3.6 Pentastar Oil Gallery plug TIP. Cam phaser Ticking...
  25. Replies
    6
    Views
    1,504

    P000A code help

    That is a cam position sensor code?

    Does your oil need to be changed?
    Are you using the correct weight oil?
    They skip bad cam sensor or wiring.

    Cause:
    ENGINE OIL LEVEL LOW
    ENGINE OIL...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Log in

Log in