Search:

Type: Posts; User: JPNinPA; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    1
    Views
    15

    Re: Weird p0300 code

    What brand and PN spark plugs did you put in?

    Random codes can come from a weak battery or poor Corroded connections
    Misfire can be injectors, intake/vacuum leak bad plug…


    Never look down on...
  2. 93 Sahara w/12v on the body, and each side of 3 fuses, WONT START and nothing works

    Between the body and the negative battery terminal you measure 12 V or between body and battery + you read 12v?

    Battery fully charged should be 12.4V
    When starting it should not go below 10v ...
  3. Replies
    6
    Views
    130

    Re: Starting problem

    That is good.
    I measured 25 ohms once when i noted the headlights pulsing.
    Replaced and cleaned contact points.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  4. Replies
    6
    Views
    130

    Starting problem

    You mention no lights, no horn that means no power. Has nothing to do with the starter solenoid.

    Did you clean the other ends? Ground to engine. Ground to chassis.

    Cables could be corroded. You...
  5. Replies
    6
    Views
    161

    Can anyone ID this TJ bumper?

    Why that over stock?
    Take the milk jug off the stock and replace with blunt plastic ends.
    Crown Automotive 55078139AA Rear Bumper End Cap for 97-06 Jeep Wrangler TJ & Unlimited | Quadratec


    ...
  6. Replies
    6
    Views
    161

    Re: Can anyone ID this TJ bumper?

    I think the bumper hitch is not rated and they added what they needed.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  7. Replies
    6
    Views
    130

    Re: Starting problem

    Have you load tested the battery?
    Cleaned battery connections and opposite end connection? Like the engine and chassis ground connections.

    Does your alternator have serviceable brushes? I had a...
  8. Re: Screws rusting on my 15 rubicon cowl and windshield pillar

    Ace hardware, fasenall or any number of places. Just match shank and thread


    Never look down on anyone unless you are helping them up - Jesse Jackson
  9. Replies
    6
    Views
    161

    Re: Can anyone ID this TJ bumper?

    There are two hitches in that pic

    Attention Required! | Cloudflare


    Never look down on anyone unless you are helping them up - Jesse Jackson
  10. Replies
    37
    Views
    22,439

    Cpl Recon's 92 YJ Project

    One site states JK are 4 with max of 5 passengers. So i guess you have to consider how big the kids are???


    Grand Cherokee L has third road seats

    Never look down on anyone unless you are...
  11. Screws rusting on my 15 rubicon cowl and windshield pillar

    These?
    24521


    If so use a sharp edge tight fitting torx. Put the torx in and heat with a torch or inductive heater… to flow the loctite then unscrew. You might go between tighten and loosen and...
  12. Replies
    6
    Views
    161

    Can anyone ID this TJ bumper?

    What’s in it for me? $191

    Is the hitch separate, combined or one unit with bumper?


    76750

    Never look down on anyone unless you are helping them up - Jesse Jackson
  13. Replies
    3
    Views
    248

    Electrical puzzle

    Worry about the Battery main connections. There are usually two grounds. One to the engine and one to the chassis.
    Then there are 2-3 power connections.


    Never look down on anyone unless you...
  14. Replies
    3
    Views
    248

    Electrical puzzle

    With electrical gremlins I recommend starting with cleaning the battery terminals and connectors. Then the opposite sides of the power and grounds. An their mating areas. Get the battery load tested...
  15. Thread: Ford gpw 1942

    by JPNinPA
    Replies
    109
    Views
    72,943

    Ford gpw 1942

    Woo hoo! is universal language of jeep!

    Nice video. Thanks for sharing.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  16. Thread: Actuators

    by JPNinPA
    Replies
    19
    Views
    2,330

    Actuators

    You have a similar issue?
    This was Feb thread about heating. Is yours a heating or cooling issue?
    You may want to start a new thread,
    What have you done so far?

    Never look down on anyone...
  17. Thread: Jeep turbo

    by JPNinPA
    Replies
    1
    Views
    204

    Re: Jeep turbo

    I don’t know of any specific recommendation when adding acyurbo.


    Never look down on anyone unless you are helping them up - Jesse Jackson
  18. Replies
    4,095
    Views
    708,712

    The OFFICIAL Random thread

    Get out and meet someone.
    I was down your way this past week. There are plenty of great people.

    Never look down on anyone unless you are helping them up - Jesse Jackson
  19. Thread: Dash cams?

    by JPNinPA
    Replies
    19
    Views
    792

    Dash cams?

    Dang!
    Your camera liked you too.
    Jealous thing quit on you when you needed it most.
    Serves you right for looking at other cameras.



    Never look down on anyone unless you are helping them...
  20. Replies
    380
    Views
    65,340

    Anyone else stuck at home?

    Well we’re back to work 100%
    Masks only if you can’t keep 6 ft apart or are not vaccinated.

    We’ll see how it goes.

    What is everyone else doing?

    Never look down on anyone unless you are...
  21. Contour Fan Controller~Mine finally gave out after 15 years

    I use a flex-a-lite black magic 485 with their controller. The fans running current is 18A and came with a 20A fuse that kept blowing. The starting current was 30+ A so I used 40A fuses and thicker...
  22. Replies
    37
    Views
    22,439

    Re: Cpl Recon's 92 YJ Project

    Do you have the correct size bump stops?
    2.5 to 3.5 isn’t a direct swap you might run into more vibes. Consider a 1.25 in body lift before going 3.5 or larger. Body lift may require 4x4 linkage swap...
  23. Contour Fan Controller~Mine finally gave out after 15 years

    Contact checking is one thing. Current checking is another. If your fan has a flyback diode and it goes south you will have an issue. A little rust dragging on the shaft or bad bearing…increased...
  24. Replies
    5
    Views
    363

    Re: New jeep doors are light

    Got a bathroom scale? Weigh them!

    I just googled it cause i was curious too,


    Never look down on anyone unless you are helping them up - Jesse Jackson
  25. Contour Fan Controller~Mine finally gave out after 15 years

    Turbogus

    Have you verified the fans are not bad drawing higher running current. Or measure the spike when starting? The spike should be about 2-3*running current.

    ...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Log in

Log in