Search:

Type: Posts; User: Thclabough; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    5,170

    Re: New to forum

    I actually pulled the starter first to I'd the engine. DOZE-6015-A block. I am getting so close to pulling the engine. I still have to get my new pry bar on the flywheel teeth. I'm cautiously...
  2. Re: JEEP TJ 97 WRANGLER 4.0 SPUTTERS AND SHUTS OFF WHILE DRIVING

    Oh, one more thing... I have heard of bad grounds causing things like this. Where the engine bonds to the chassis, sometimes the connection is compromised because proper surface prep was not done,...
  3. Re: JEEP TJ 97 WRANGLER 4.0 SPUTTERS AND SHUTS OFF WHILE DRIVING

    Hi all, I hear you, and having various vehicles and troubles with same. Man, that's a tough one. It sure sounds like fuel filter, but electronics tend to have trouble with heat. However, anything...
  4. Replies
    15
    Views
    5,170

    Re: New to forum

    Sometimes I wish I had a Wrangler.....NOT. Too much fun reviving my CJ5 beast.
  5. Replies
    15
    Views
    5,170

    Re: New to forum

    Well, didn't quite get it out of the e garage. I noticed the tires were low, so I fired up my compressor to take care of; However, when I tried to air up the tires I found the cores all gunked up....
  6. Replies
    15
    Views
    5,170

    Re: New to forum

    Oh, I will get some pictures once she is outside. Gonna be some dirty pictures, so be careful showing children. Lol!!
  7. Replies
    15
    Views
    5,170

    Re: New to forum

    Somewhat at a standstill. I took my breaker bar and a cheater. I put enough pressure to unseize, however the crank bolt just tightened some with no engine movement. My next trick is to, well gotta...
  8. Replies
    9
    Views
    3,184

    Re: 98 grand cherry clutch

    Awesome, I haven't got to my clutch on my 55 cj5. Trying to get engine unsized. I'll probably set up a hydraulic system when I get there.
  9. Replies
    5
    Views
    12,302

    Re: Looking for places to camp with our Jeeps

    We used to go up to forresthill. Take the Cool hill turnoff. At the bottom stay left instead of turning right towards the town of Cool. Follow for awhile... you're looking for Finneymill Rd. Take...
  10. Thread: fast Jeep

    by Thclabough
    Replies
    10
    Views
    11,509

    Re: fast Jeep

    Holy cow!! I was going to brag about my '70 boss 302 in my '55 CJ5. But, I have to pick my jaw up off the floor after reading your post. I am just trying to build a really good crawler. I'm putting...
  11. Replies
    9
    Views
    3,184

    Re: 98 grand cherry clutch

    So long as it, the clutch, is fully disengaging and engaging there isn't any obvious urgency. If the peddle comes a good inch or two off the floor before engaging, it sounds ok. Is there any...
  12. Replies
    15
    Views
    5,170

    Re: New to forum

    Ran out of diesel, got some more tonight. Will add some more tomorrow. Slowly but surely. It looks like one week has turned into two. It will probably never be as nice looking as your Wrangler, but...
  13. Replies
    41
    Views
    93,464

    Re: TerryMason's 2005 Jeep TJ Build

    Wow, I really enjoyed checking out your Wrangler upgrades. I'm still trying to unseize engine. I have a 4" lift kit on a shelf in my garage...new springs, shocks, boots. I also purchased a NP 435...
  14. Replies
    15
    Views
    5,170

    New to forum

    Hi all, Tom Clabough here. I'm currently working on my first real jeep...a1955 CJ-5. I had it trailered from Northern California to here, Temecula. Long story of how I acquired her, but she's mine...
  15. Replies
    6
    Views
    2,133

    Re: In need of Electrical assistance.

    I would start with fuses and relays. Oh, I see you found the problem...awesome. I've been an electrician for over 30 years, but when it comes to low voltage stuff (12v etc.) that's the first place I...
Results 1 to 15 of 15

Log in

Log in