Search:

Wishing you the best of luck !
Most of all , a better future and benefits for you and family .

A 1973 jeep cj5 . It's currently a project / restoration still awaiting a start date due to funds and time . Hoping for both of those to fall in place soon .

Yes sir , sure has . With these new scattered work hours and unpredictable overtime , I sure could use a secretary to keep up ! Wrenching weather is finally here , now it's time to make $ !

Thank you Dana for choosing jeepz.com for your research feedback ! Welcome and grazie !
I agree that simplicity is key . We like jeeps to be simple and down to earth , user friendly and easy to...

The front Dana 30 axle dosen't have the " C " clip at each axle end inside the differential case side gears like the rear axle does. So , no problem there . As long as the axles were pulled out ,...

Sure glad you posted a picture of the front hub assembly of your jeep .
the axle in this jeep , from the Range Rover , is completely different from a Dana 30 open knuckle axle . You could not order...

I'm no mechanic either but I believe you guys are on the right track .
Although it should not be ruled out , a fuel restriction is less likely than a bad electric fuel pump .
It could not hurt to...

Welcome to jeepz.com.
have you checked for a blown fuse ? Also , you may have a bad blower motor resistor or bad blower fan switch . A motor , switch or resistor will pull more amps than the fuse is...

Welcome to jeepz.com
you mentioned that the neutral safety switch has been changed and that you have to move the shift lever to get it to crank . You'll have to check the adjustment again , it's...

Although I don't truly know the going rate for a shop or dealer to perform the repaair(s) you need , I still think that estimate you've received is somewhere between high and outrageous.
i do my own...

Also , as Djs jeep posted , the cam sensor will have to be checked as well .
Youll want to know if it's receiving 12 volt reference and if a signal feedback is present .
Both , the cam and crank...

Be sure there isn't any kind of anti-theft deterrent system ( factory or aftermarket ) of any kind that could be the cause of ignition system cut-off. Usually those systems also prevent crank as well...

From your description of the fault , it does sound like the starter has an internal short .
An amperage draw test would have to be performed but that is a little involved if you don't have proper...

I know the feeling . I'm 10pm - 6am now with 7pm start times straight through to 6am twice a week and anything else that might come my way . Got to save up $$ for the jeep projects .

I'm not that far advanced in automotive electrical but it does sound to me that if in fact the electrons are flowing in reverse , a diode is missing or not working . A diode is used to allow the flow...

From my last post , I stated that adjusting 2 degrees at a time from initial timing be made for best performance . This should only be done if the factory recommended timing setting could profit from...

I really advise confirming proper initial timing before carburetor adjustment .
you don't want to tune or be able to attempt with timing out . Too rich will build carbon and too lean will cause...

Hello and welcome to jeepz.com
was wondering if you did try the distributor installed 180 degrees opposite of the way it was first installed . Although I don't like to guess , the only way to be...

I'm famiar with bolts holding the CPS in as well . But reading back in your post stating you cannot remove the CPS because you cannot get it off the two studs got me to research . I don't have proper...

Although I cannot provide correct firewall bulkhead connector or PCM cavity pin out to probe with a computer safe test light it low impediance digital voltmeter , it is still good practice to carry...

Sorry I don't have proper reference for your ZJ , I tried to follow along with my 1992 factory service manual to see if it would be if any help . I could not find the battery + input for the PCM...

Hip to be square

Guess he didn't like the square headlights ? Well , you know he's got a good jeep now ! The looks of a CJ and the integrity of a YJ wrangler ! Can't go wrong . Nice Camo too !

Agree with above post . The 2.5 liter or the 4.0 ?
Also , the second post shows a CJ7 trailered . You mentioned a trade , was it the CJ for the YJ ?

Pardon me for saying , but the jumpers on the fog light switch are crossing each other which most definitely will cause an arc. Sorry about that �� .