Search:

Type: Posts; User: PoliceMonkey161; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    2,490

    Re: Safari rack for 1985 CJ7

    Not sure why you posted these photos and highlighted my quote?????
  2. Replies
    6
    Views
    2,490

    Re: Safari rack for 1985 CJ7

    Other than how the tailgate opens, none.
  3. Replies
    6
    Views
    1,759

    Re: Transmission and T-case fluid

    If it where me and it has been many times, for the Tremec T4 and T5 transmissions (non-world class like those in your Jeep), you'll need a gearbox oil with anti-oxidation additives like Pennzoil...
  4. Replies
    4
    Views
    2,149

    You may also have a interlock on the electric...

    You may also have a interlock on the electric fuel pump that is dependent on oil pressure (which is the way they are supposed to be wired). The wiring in this type of situation can be difficult to...
  5. The motor mounts are different on the YJ to ...

    The motor mounts are different on the YJ to accommodate the larger oil filter that was used by Chrysler. AMC 's design had an internal to the block oil bypass and drain back valve, the Chrysler...
  6. Replies
    5
    Views
    1,292

    Try Magoo's Auto Glass. I got one for my CJ7 from...

    Try Magoo's Auto Glass. I got one for my CJ7 from them a couple years ago.
  7. Replies
    6
    Views
    2,264

    At 28 degrees you have likely skipped/slipped the...

    At 28 degrees you have likely skipped/slipped the the timing gear and chain.
  8. Thread: clutch

    by PoliceMonkey161
    Replies
    1
    Views
    1,530

    Re: clutch

    The clutch will start slippping under load. You'll see a random spike in your RPM's with the pressure plate fully engaged (your foot is not on the pedal). Depending on what model Jeep you have, check...
  9. Replies
    6
    Views
    4,204

    X2 on the install, not so much hard as time...

    X2 on the install, not so much hard as time consuming to set up the first time. Superior Axle made a very good kit with clear instructions, but they went out of business.

    Most 4x4 shops (like...
  10. Replies
    25
    Views
    6,233

    How is your Jeep running?

    How is your Jeep running?
  11. Replies
    17
    Views
    2,981

    X2 on this..... The SOA is a fools game for a...

    X2 on this..... The SOA is a fools game for a daily driver or even a recreation vehicle. If the engineer 's at AMC, Chrysler or whoever wanted it that way, they would have made it an option. You'll...
  12. Replies
    6
    Views
    4,204

    Sorry...... Fat figured this with my iPhone....

    Sorry...... Fat figured this with my iPhone. You'll be able to remove it but not re-install it. The rest is what I was getting at...
  13. Replies
    6
    Views
    4,204

    You be able move it but not reinstall it....

    You be able move it but not reinstall it. Regardless, I would recommend a 1 piece axle upgrade.

    Welding the hub to the shaft is an old school fix for a slipped / stripped key. When you price out...
  14. Replies
    8
    Views
    1,487

    Re: 1989 wrangler 4.2

    You are correct, you have no Crank Position Sensor. In fact, you have one of the last AMC engines made which had rudamentary electronics at best (still a great engine though). The fact that you can...
  15. Replies
    17
    Views
    2,981

    Re: cj5 direction

    Based on your photos, I argee with 69jeepcj with regards to the front axle or really what we are getting at is your caster angle. One of your photos shows the angle meter at 10 degrees negitive...
  16. Replies
    3
    Views
    1,431

    Re: First of many questions...

    The dome shaped unit is the pressure sending unit for your oil pressure gauge on the dash panel. The 2 prong unit is a normally open oil pressure switch which was typically used for the electric...
  17. Re: 78 cj5 upper fresh air duct ???? by the newbie.

    I would recommend taking the dash plate off to re-install the correct OEM heater assm. Otherwise you're going to disconnect a bunch of wires that are hard to get too. It's confusing enough even if...
  18. Replies
    13
    Views
    3,930

    Re: Help twin stick my 85 cj7

    If you where to look at your T-case from under niether your jeep, you'll see that it is actually two seperate shifting rods(rails) connected to a common gear shift lever as the OEM setup. Twin stick...
  19. Re: 78 cj5 upper fresh air duct ???? by the newbie.

    See attached photos. You need the upper half of the plenum (air duct).

    2014320142
  20. Replies
    1
    Views
    1,240

    The harmonic balancer/vibration dampeners where...

    The harmonic balancer/vibration dampeners where all the same regardless of trans type, so no you won't need to change it.

    However, down the road, keep in mind with the CJ 258 engine that you are...
  21. Replies
    13
    Views
    4,818

    Re: Squeaking noise from the front wheel

    Star,

    While everyone has given you great insight to the potiential problem (as everyone here is famous for), do yourself the first favor as Greg mentioned and tear-down/inspect your front axle...
  22. Replies
    10
    Views
    1,988

    Re: Clutch problem

    Whoever told you to try a new pivot bearing and/or clutch fork is going under the assumption that your clutch travel is binding and will not travel the full lenght of the stroke. If you competely...
  23. Replies
    13
    Views
    3,930

    Here, try this. It is what I used my last build...

    Here, try this. It is what I used my last build and was very happy with it and its only $99.

    http://jb-custom-fabrication.myshopify.com/products/jeep-d-300-stainless-steel-twin-stick-shifter
  24. Replies
    13
    Views
    3,930

    Unless you have a really custom Jeep, you don't...

    Unless you have a really custom Jeep, you don't need the cable-shifter model. There should be a standard twin stick direct connection one specific to CJ on his site. They are about $140 if I remember...
  25. Thread: head?

    by PoliceMonkey161
    Replies
    8
    Views
    11,506

    Re: head?

    They won't mate up and even if they would somehow, you'd have issues with the intake/exhaust ports that would not seal or match up, the guides for the push rods would be all catty-wonkgus and coolant...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Log in

Log in