Search results

yep id believe quad cities. im in the blo no area. and sometimes ill spend the time in nw indi area. no cj over here though. don't see too many of those in illinois either. or maybe i'm just not looking hard enough

only in a jeep!

my 4 banger does fine going on the highway. Im running 31s and i can pull 65 if not 70 on the highway. that is until the D35 popped. lol

see I've never taken out a rear end and replaced it, that's why I was thinking of spending the 20 bucks for the gears for the dana 35, but if it's complicated and more difficult than just swapping out ill just swap. I would still need to research all that is needed to do this project. I am...

So i found the gears from a 95 that would fit my jeep for 20 bucks. My question is how hard would it be to rebuild the rear end? seeing as all the gears were in pieces when i opened her up, I dont know how difficult or where they fit in. Any advice would be great. I was going to upgrade to a...

checked out the cijc but there isn't much on there at the current time lol

well once I get a new rear end I'm gonna need the plates welded and the axles welded too

Lol damn typo. Ok I appreciate the info. Ill make sure I do that. Soon as I find an axle that is

These are the factory standards for the YJ: 2.5L manual - 4.10 2.5L auto - 3.73 4.0L manual - 3.55 4.0L auto - 3.07 found the answer myself lol

1992 ford explorer rear end . 3.73 ratio. Would this work on 95 jeep yj 2.5 manuel?

hmm. I think I will try the 8.8.

i will probably get one out of the scrap yard. What do you guys think the best rear end to look for would be?

anyone have a dana 35. or dana 44

Anyone around Illinois has a rear end laying around? I'm looking for a 95 yj . Dana 35 I believe.

found out the rear diff is broken. opened it up and the gears are in pieces. Rebuild or swap? what would be better

is this good?

At what angle is the rear drive shaft supposed to be at on a 4in lift?

yessir! now the stallion is back up for sale.

well there you have it. Thanks bounty. Now I don't have to think about how to fabricate a mount for it since its just hanging there and has nowhere to latch onto on the rear end.

can someone post some pics of the rear end of a yj. I have a rear trac bar extension for the lift I purchased. I am not sure where it goes.