Search results

thanks for the info..

just bought a 98 with the infinity sound system, the drivers door is blown and the passenger door does not make a sound. i would like to know the size of them so i can replace. them. i moved up from a 88 to a 98 cherokee.

what is the torque on the 4.2? i went to auto zone and got the bearings, they said 30 lbs. i did that , drove it and it started to rattle. they must be wrong!!! thanks, rick

ok now how do i make sure oil is up to the top before starting the engine?

when replacing the crank shaft what all must i do? i have a chilton 's and a haynes but do i have to replace the rear main seal? any directions would be helpful. thanks in advance.

can i usen a crak from a 4.0 in a 4.2?

it is loud, sounds like chinese fighting men, but there is no loss of power. it will quite down and not ping at all. there is a high pitched noise that happened twice, then i turned around and went back to my mothers house. it will make noise and then it will be very quite. when i removed the...

i might have to leave the jeep here. i have to be back in the morning for work.

ok, i left kansas city on thursday and had a problem with the jeep. i replaced all the rod bearings, they weer really loose. now ther is more noise than before. can anyone help me . thanks a lot.

i am out of town and the jeep starts rattlin. it is the bearings. i start to drop the oil pan, and cannot get it off. i tried to raise the motor as someone else suggested) and i could not get it out. i went to this link http//www.jeepin.com/features/rearmain/index.asp and found out you can...

there are not any straight six carb cherokees from the factory, it has the renix setup. do you have any idea what the markings on the side of the motor mean? thank you very much. btw are there any trails in the nashville area?

as i stated before it is a inline six, so therefore it must have six spark plugs. but i guess you knew that from reading the post. the question is how do i tell if it is a 4.0 or a 4.2.

i got a cj engine in my cherokee, can someone tell me the size. it is a straight 6. or how do i tell from the markings?

straight six,1989

i replaced the engine in my xj, it was a strait swap. on the side of the motor was stamped cj. can any one help me with the size of the engine. or tell me what to look at. btw thanks for answering the poll. ricpope

is it better to remove the engine and transmission or just the engine when replacing the engine?

with my jeep. i found this article. http://www.angelfire.com/my/fan/Power_Cables.html thanks to dino. hope this helps.

i found one from a pre 97 to a post 97 check out this site. http://www.go.jeep-xj.info/BensXJ.htm

when i start up the engine taps loudly, when i am on a hill with the front end down it does not tap. any ideas?

is this possible?