Search results

  1. vinn

    jeep yj 1994 engine replament adapter

    at the last jeep swap meet i got an aliminum adapter plate marked "AA FJ504". ford v8 ( maybe ford 6 cylendar) to "some kind of jeep transmission". can any one tell what it fits? vinn
  2. vinn

    Engine swap issues

    do you mean "water in the eng. oil" ? i have a 94 yj with an internal eng. crack AND water in the oil. it runs and i use it, but i don't want to put another "italian made" in it'
  3. vinn

    Drones - good or bad?

    the Trump predator drone will be available early in 2018​. if you would like to be a retailer for this product, write too "uncle Don", general delivery district of Columbia.
  4. vinn

    Speedometer jumping

    speedometer cables; it is easy enough IF you have a cable connected to the speedometer. the electric one can be repaired also. if its the CABLE type, unscrew the cable from the transmission - right away ! remove the inner cable and lube it ( the proper cable might be hard to find). don't...
  5. vinn

    What did you do to your Jeep today?

    94 yj drain " check valves". i removed the plugs and added a "loose fit carriage bolt" [no carpets] that lets water pass. i dont know where that water comes from, but i suspect the air box on the cowl. vinn
  6. vinn

    4 burner no power

    besides power, some like to drive on the freeway, that means 70 mph just to keep out of the way. not an easy solution to that.
  7. vinn

    jeep engine

    looking for an old postal jeep 4 cyl. eng. rebuildable. vinn
  8. vinn

    Parting out postal Jeeps--Good prices? I have no idea

    id like to have an early 4 cyl. chev "iron duke" not the later chev or the kizer italian made. they were in the very early postal. vinn
  9. vinn

    4 burner no power

    the 4 cyl. italian will have a very short life. haveing a jeep with a stock 4 wount sell or it will spon an angry buyer. we need to come with a small, well made engine and easy inter change. vin
  10. vinn

    4 burner no power

    thanks for the tire info.. its not for jeeps and thats why i have a crawler tractor. vin
  11. vinn

    Engine swap for '07 JK

    super chargers and computers should be put on strong engines. the old buick 322 v8 would go 6,000 rpm from the factory. the chev small block can be made to turn high r.p.m.'s. there is nothing from the factory jeep that will do that. i think you are stuck with an engine swap. vinn
  12. vinn

    4 burner no power

    i knew they used gas on rubber tires on tractors or was that some liquid for weight? heavier tires on a jeep would help to keep it "upright", but hard to change. vinn
  13. vinn

    What did you do to your Jeep today?

    well, today ill try to explain the two pix [above] showing the front rotor (94 yj). the two bolt caliper has been removed. note , one of the two bolt tabs is BENT. the caused problem was "occasional brake seize up", AND skid,smoke and PANIC. with torch and hammer, i put the tab back in...
  14. vinn

    4 burner no power

    VERY GOOD ADVISE ! i learned something about the first chev s-10 4 and v-6 (2.8) [assembled in mexico) these eng.'s also killed the fiero car, but i have a quality U.S. rebuilt 2.8. - ran it hard, till the trans. failed. i'll put it next to the chev 350 for the next project...
  15. vinn

    4 burner no power

    southern wolf; thanks again. the buick idea, the old 322 v8 had high torque and was quite narrow. i put one of those up to a 4speed in an old chev truck (when i was a kid). i have a first yr. s-10 chev, v-6 eng. with the cable clutch bell housing and a couple good engines. what do...
  16. vinn

    4 burner no power

    wow Hunter, thanks. i am going re think this project, continue assembling the chev 350 for some other project. i knew that 5 speed was weak when i first drove it. i have an s-10 pickup with a 5 speed that i thought was quite strong, but the guy who put a 350 in front of it proved me wrong...
  17. vinn

    4 burner no power

    thanks, what is the AX15? i dont need high tourk. only up hill in the mud to fall trees AND hopefully highway speeds for lunch. a replacment engine is the priorty. is there chance the existing trany and transfer gears would hold up? thanks again for the reply. vinn
  18. vinn

    4 burner no power

    good to hear your plan for the 4/8 swap ! (thanks) i am progressing on my chev. 350 eng. out of a van i usedto drive. (automatic). got the fly wheel, clutch and pressure on the engine. have 3 different iron bell housings to select from. now need to buy grade 8 bolts for the pressure plate...
  19. vinn

    What did you do to your Jeep today?

    replaced front caliper on yj 1994 lets see if i can attach two pix.. there it is. note the bent caliper tab ! solved the mystery of why caliper ceased occasionaly. i plan to heat the tap and drive back into line. i did buy a new caliper (94 jeep yj used a GM caliper). vinn p.s...
  20. vinn

    What did you do to your Jeep today?

    94 yj front brake disk caliper replaced. story and pix later. Vinn
Back
Top