Search results

1041601 I have the t-150 transmission withe the model 20 transfer case. After a rebuild I am having a problem with oil from the transmission migrating to the transfer case. the transfercase then fills up and oil come out of the vent cap. I think that this is the seal on the input shaft...

1041666 I am looking to replace my t-150 3-speed with at least a four speed and a five speed if at all possible. I am looking to run a little better gear ratio to try and help to improve gas milage. Does anyone know what transmissions mate up to the 304 bellhousing and also work with a model...

1041667 I am trying to clean the garage I I have a few parts that I need to get rid of. Just e-mail me if you are intrested and I will send any pictures that you would like. Buyer pays shipping. 1. Bestop soft half doors for cj5 2. Model 35 front axle shaft housing, both axle shafts...

1041901 I am having a problem with my 304 venting oil out of the filler spout. I have the edelbrock performer intake manifold and also the edelbrock 650 cfm carb. I have the pvc valve in the spot directly behind the carb and the vent hose pluged into the front of the carb where there is the...

1042202 Hi all I have a 76 cj5 with a 304 I cannot find the duct work that goes from the lower airbox to the defrost ducts any where. Does any one out there know where I can buy these pieces. I was also curious if anyone has swapped the entire interior air boxes and heater core out for a...

1041536 I had a few questions about a 350 swap. 1. What would be the most economical fuel injected motor to use for this swap? 2. If this swap were performed what would be the best transmission/transfercase combo to use? 3. How hard would it be to modify the wiring and computer to...