Search results

Thanks for the info Bounty . . .

I've got an '84 Cj7 with a rear Dana 44 from a 87 Cherokee XJ w/disks and and ARB locker. I noticed diff fluid dripping from the brake dust cover and an accumulation of it in the inside of the rim. I assume it's a seal? Where is it located and how difficult are these to replace? How is the axle...

Update: Went to fastenall for studs to replace bolts and he presented me with the Nord-Lock Bolt securing system. Here's what their website says: "Nord-Lock bolt securing systems use geometry to safely lock bolted joints in the most critical applications. The key is the difference in angles...

Hmmm, something to think about! Thanks!

I do believe that is correct.

I apologize for not being clear :( , it's got Dana 44's front and rear with an '82 hub assembly.

Thanks!

While in Moab this last week, I decided to take a look at the bolts holding my Superwinch (junk) hubs to the hub/rotor assembly flange as I'd been having trouble keeping them snug. Wouldn't you know, two of them where sheared off leaving the stud in the hub flange. I now only have two bolts (one...

The lug pattern is standard CJ7. What I can't figure is the SOA vs SUA. I think the K20 was SOA. This setup looks to be stock CJ7 spring setup. It could be that the Dana sight has the numbers wrong.

In the interest of getting to know my newly acquired 1984 CJ7 a little better, I've been nosing around underneath and have found that the front axle is a Dana 44 (ARB locked). I understand this isn't stock for that year so I manage to remove enough rust from the axle and all but one numeral of...

Thanx all for your input. You've been very helpful!

I took the Jeep I'd just purchased to Moab on it's debut run and it performed great, no problems. Took it for a spin the other day and ran over some railroad tracks and while coming off them the Jeep started a violent shaking with the shifter moving from side to side. Reproduced it on the return...